Weller WD 2000 Mode D'emploi page 33

14-18
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
Setting the temperature offset
The real soldering-tip temperature can be adapted by entering a
temperature offset around ± 40 °C (± 72 °F).
1. Select the menu item OFFSET in Menu 1.
2. Set the Auto-OFFSET temperature value with the UP or DOWN
button.
3. Proceed to the next menu item with the button ┌ 1 ┐ (back) or
┌ 1·2 ┐ (forward).
Setting the window function
It is possible, starting from a set, locked temperature, to set a
temperature window of ± 99 °C (± 180 °F) with the aid of the
WINDOW function.
Note To be able to use the WINDOW function, ensure that the soldering
station is in the locked state (see "Switching the lock function
on/off").
1. Select the menu item WINDOW in Menu 1.
2. Set the WINDOW temperature value with the UP or DOWN
button.
3. Proceed to the next menu item with the button ┌ 1 ┐ (back) or
┌ 1·2 ┐ (forward).
Switching the temperature unit
Switching the temperature unit from °C to °F or vice versa.
1. Select the menu item °C / °F in Menu 1.
2. Set the temperature unit with the UP or DOWN button.
3. Proceed to the next menu item with the button ┌ 1 ┐ (back) or
┌ 1·2 ┐ (forward).
Switching the lock function on/off
When the lock has been switched on, only the temperature buttons
┌ 1 ┐, ┌ 1·2 ┐ and ┌ 2 ┐ on the repair station can still be operated.
All other settings are disabled until the repair station is unlocked
again.
Lock the soldering station:
1. Select the menu item LOCK in Menu 1.
"OFF" appears in the display. The padlock symbol flashes.
Note Pressing the buttons ┌ 1 ┐ or ┌ 1·2 ┐ while "OFF" is displayed
results in the menu item being exited without a stored lock code.
2. Set a 3-digit lock code with the UP or DOWN button.
3. Press button ┌ 2 ┐ for 5 seconds.
The code is stored. The padlock symbol is displayed. The station
is now locked. The display switches to the main menu.
WD 2/ WD 2M