Haag-Streit BM 900 Mode D'emploi page 27

C Additional maintenance routines
C. Replacement of the mirror
Removal of the mirror is easiest when the microscope and
illumination unit are well separated and the latter inclined by
10° or so.
C. Cleaning of the optical parts
A dust brush is to be employed for dusting the exposed glass
surfaces.
Not for LI 900 : From time to time it is necessary to clean
®
the upper surface of the condenser. The condenser surface
is now visible and can be cleaned with a brush for cleaning
the optics. Surfaces which have become really dirty should
first be dusted, then wiped carefully with a soft dry clean cloth,
washed linen, chamois leather, or some such material which
will not scratch the surface.
Brush for cleaning the optics
HS-Part number 1001398
C.3 Adjustment of friction of the slit width control
The friction of the slit width control (79) can be regulated
by means of the small screw in the centre of the right hand
control. The movement can be stiffened by turning the screw
clockwise or loosened by turning it counter-clockwise. The
screw should be at least tight enough to ensure that the slit
does not close spontaneously.
C.4 Cleaning of the gliding plate and the rails
If it becomes difficult to move the slit lamp around on the
gliding plate (83), the plate should be cleaned with a slightly
oily rag.
After removing the rail covers (82), the rails (80) should be
cleaned with a stiff brush.
C.5 Cleaning of the axle ()
Clean only with dry, lint-free cloths!
C. Plastic dust cover
It is recommended to protect the slit lamp with a dust cover
in case it is not in use.
Plastic dust cover, small (for slit lamp)
HS-Part number 1001395
Plastic dust cover, large (for several instruments)
HS-Part number 1001434
79
80
81
82
83
1500.7200492.04110
Stiftschlüssel 2 mm
Clé à 6 pans 2 mm
Allen key 2 mm
© Haag-Streit AG, 3098 Koeniz, Switzerland