Rear Panel - Onkyo A-9110 Mode D'emploi

Rear Panel

  
1. SPEAKERS terminals: Connect speakers with speaker
cables. (p9)
0 North American models are banana plug ready. Use
plugs with a diameter of 1/8" (4 mm).
0 Not all models support connection with Y plugs.
2. Power cord (p12)
3. GND terminal: The ground wire of the turntable is
connected.
4. PHONO MM jacks: Use an Analog audio cable to connect
a Turntable that uses an MM type cartridge. (p11)
5. LINE IN jacks: Input audio signals from a playback device
with an analog audio cable. (p10)
6. LINE OUT jacks: Use an Analog audio cable to output
audio signals to recording equipment, such as a cassette
tape deck. To select the input source for recording, use
the INPUT dial on this unit or use the remote controller.
7. SUBWOOFER PRE OUT jack: Connect a powered
subwoofer with a subwoofer cable. (p10)
8. RI REMOTE CONTROL jack: This jack is for linking when
you connect an Onkyo CD player, tuner, network audio
player, or RI dock that has an RI ("Remote Interactive")
jack. (p11)
6

 
Before use

