Publicité
Les langues disponibles
Les langues disponibles
Defrosting the refrigerator
The refrigerator does not have to be defrosted
but it does have to be cleaned.
The refrigerator's evaporator is fixed into the
rear wall, which is why the rear walls can be-
come covered with frost. Whenever the com-
pressor is not working, frost can melt. The
resulting water is led through a hose system
to the basin on the compressor, where it then
evaporates due to the heat generated. When
setting the temperature controller, avoid per-
manent frost without a defrost phase.
Make sure that the drain gully and the drain
opening are not blocked so that the water
produced in the refrigerator can always flow
off unobstructed.
Tips for Energy Saving
• For the installation of the appliance, choose
a cool, dry and well-aired room.
• Protect the appliance from direct insolation.
It should not be installed near heat sources
(stove, heater etc.). If this cannot be avoid-
ed, some sort of isolation between heat
source and appliance has to be used.
• Don't cover the ventilation openings and
grid. Provide enough circulation of air on
the backside of the appliance.
• Let warm food cool down before you store
it in the fridge.
• Do not leave the door open too long when
withdrawing or putting food inside. Other-
wise, the formation of ice in the interior will
be accelerated.
• Do not set the temperature lower than
necessary. More details on temperature
settings can be taken from the chapter
'Controls and Display'.
Operation Noises
There might be some typical operation noises
when the appliance is turned on. These are:
• Noise of the electric motor is arising from
the working compressor. When the com-
pressor starts to operate, then the noises
get slightly louder for a short time.
• Noises in the tubes of the circulation of the
refrigerant.
Disposal
Appliances that are marked with
this symbol have to be disposed of
separately from household rubbish.
These appliances contain valuable
resources that can be recycled. A
correct waste disposal protects the
environment and the health of those around
you. To get informed about it, either defer to
your municipal administration or the retailer.
• Pull the mains plug out of the socket and
disconnect it from the appliance before
getting rid of it.
• The cooling medium Isobutane
(R600a) and the propellant in the
isolation Cyclopentane (C 5 H 10 )
are inflammable substances,
thus, need to be appropriately disposed of.
• Make sure the tubes of the cooling circuit
don't get damaged before the proper
disposal.
Warranty
Severin grants you a manufacturer's war-
ranty of two years starting from the date of
purchase. During this period, we eliminate
all defects which are noticeably based on
material or fabrication defects and sub-
stantially affect the function, free of charge.
Further claims are excluded. The following is
excluded from the warranty: Damages that
result from non-observance of the instruction
manual, improper use or normal abrasion,
also delicate parts, e.g., glass, plastic or
light bulbs. The warranty expires in the case
of an intervention that is not authorized by
us. If a repair is necessary, call and write an
e-mail to our after-sales service. The contact
details can be taken from the appendix of the
manual. The legal warranty laws against the
vendor and possible vendor warranties stay
untouched.
- 23 -
Publicité
