EUROM Hot Shot 2000 Wifi Manuel D'utilisation page 34

Remote control
7. Temperature higher
8. MODE button
- Ventilate (LED ring goes blue)
- Low power heating (1000 W) (LED ring
goes green)
- High power heating (2000 W) (LED ring
goes red)
9. ECO setting, the thermostat is set to 16°C
10. Temperature lower
11. 3 colour LED ring ON/OFF
12. ON/OFF button
13. Oscillate
Installation and Connection
 Remove the packaging materials and keep out of the reach of children. After
removing packaging, check device for damage or any evidence that may point to
a defect/failure. If in doubt, do not use the device but refer to your supplier for
checks/repairs.
 Choose a suitable place for the device, taking into account all warnings
mentioned previously in these instructions.
 Check whether the Main switch is set to OFF (O).
 Unroll the electrical cable entirely and insert the plug into a suitable 220-240V
socket: In order to avoid an overload, make sure no other devices are connected
to the same group.
 Switch the heater on by setting the main switch to I (ON). The heater is now in
stand-by.
 The heater can now be operated manually, with a remote control or with an app.
Operating
Operation using heater panel (manual) and remote control
1. Press on the button
temperature. The thermostat starts on 21°C and high power heating, LED ring
is red and there are 3 dots on the display.
NB: if the ambient temperature is lower than 21°C, the heater will heat for a
while at full power. If the ambient temperature is higher than 21°C, the heater
will start to ventilate.
2. Press the button
the display shows:
 1 dot (just ventilate),
 2 dots (low power heating)
 3 dots (high power heating)
to start the heater. The display shows the ambient
to change the mode, each time you press the button
34