EUROM Hot Shot 2000 Wifi Manuel D'utilisation page 33

the socket immediately. Take the entire device back to your
supplier or a recognised electrician to be checked and/or repaired.
Always ask for original parts to be used.
4. The device may only be opened and/or repaired by a competent
and qualified person. Do not carry our your own repairs as this
could be dangerous! Repairs carried out by unauthorised persons or
changes made to the device could damage the dust/waterproof
capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the
manufacturer, their service department or somebody with similar
qualifications in order to prevent creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or
personal injury. They will invalidate the guarantee and the supplier,
importer and/or manufacturer shall not be liable for the consequences.
Description
Heater
A. Main switch ON/OFF (back)
B. Air output grille
C. Display
D. Operating panel buttons
E. Handle (back)
F. Remote control
Operation panel
1. Temperature higher
2. Temperature lower
3. ON/OFF button
4. MODE button
- Ventilate (LED ring goes
blue)
- Low power heating (1000
W) (LED ring goes green)
- High power heating (2000
W) (LED ring goes red)
- Hold ECO setting in for 5
seconds, the ECO setting will
set the thermostat to 16°C.
5. Oscillate
6. LED ring
33