Bosch EasyRotak 36-550 Notice Originale page 20

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
20 | English
Temperature Monitoring of the Garden
Product's Electronics
The red LED lights up continuously when pressing the On/
Off switch: The temperature of the garden product's elec-
tronics is below 5 °C or above 75 °C.
At a temperature above 90 °C, the electronics of the garden
product switch off until the temperature is within the allow-
able operating-temperature range again.
Cutting Capacity (Battery Operating Duration)
The cutting capacity (battery operating duration) depends
on lawn properties, such as grass density, moisture content,
grass length and height of cut.
Switching the machine on and off frequently during cutting
will also reduce the cutting capacity (battery operating dura-
tion).
Troubleshooting
Problem
Possible Cause
Motor refuses to start
Internal wiring of garden tool defective
Battery discharged
Battery too hot/cold
Grass too long
Motor protector has activated
Isolator key not inserted correctly/fully
Garden tool functions
Internal wiring of garden tool defective
intermittently
Motor protector has activated
Machine leaves ragged
Height of cut too low
finish
Cutting blade blunt
and/or
Possible clogging
Motor labours
Blade fitted upside down
Blade not rotating
Cutting blade obstructed
while garden product
switched on
Blade nut/bolt loose
Excessive vibrations/
Blade nut/bolt loose
noise
Cutting blade damaged
Battery and charger
F 016 L81 912 | (06.02.2020)
To improve the cutting capacity (battery operating dura-
tion), it is recommended to cut more frequently, increase
the cutting height and walk at an appropriate pace.
The example below shows the connection between cutting
height and cutting capacity with regard to three batteries.
Cutting Conditions
6cm
4cm
Very thin, dry grass
Cutting capacity
Battery with 2.0 Ah
up to 250 m
Battery with 4.0 Ah
up to 500 m
Battery with 6.0 Ah
up to 750 m
To increase the run time an additional battery can be pur-
chased from an authorised customer service agent for Bosch
garden products.
Corrective Action
Contact Bosch customer service agent
Recharge battery
Allow to cool/warm
Max. allowed grass height 15 cm on highest
height-of-cut setting
Allow motor to cool and increase height of cut
Fit correctly
Contact Bosch customer service agent
Allow motor to cool and increase height of cut
Increase height of cut
Replace cutting blade (see figure K).
Switch garden tool off and disengage isolator key
Check underneath the garden product and clear
out as necessary (always wear protective gloves)
Refit blade correctly
Switch garden tool off and disengage isolator key
Clear obstruction (always wear protective gloves)
Tighten blade nut/bolt (22 Nm)
Tighten blade nut/bolt (22 Nm)
Replace cutting blade (see figure K).
2
2
2
Bosch Power Tools

Publicité

Table des Matières
loading

Table des Matières