EUROM Safe-t 1000 Manuel D'utilisation page 13

Location and Connection
Remove all packaging material and keep out of reach of children. After removing

packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
Choose a suitable location for the heater which is at least one metre away from

any obstructions, walls or inflammable materials (see also safety instructions).
Make sure a functioning heater is always placed on a solid, flat and horizontal

surface.
Check if the mode selector dial is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 220-240V socket. To prevent

the circuit overloading, check that no other appliances are connected to the same
group. The pilot-light will turn on.
Set-up and Operation
Switch the heater on by turning the mode selector dial to
one of three positions:
Fan only
500 Heating at half power (500W)
1000 Heating at full power (1000W)
It is most economical to heat the space at full power, then to switch to half power to
maintain the temperature.
Both at half and full power, the fan rotates at the same speed; the difference

between the two lies in the number of heating elements in use.
To switch the heater off, set the power dial to '0' (off). Unplug.

Safety features
The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal but, before reusing, switch off, unplug
and check for damage. Do not use the heater if it is damaged or malfunctioning, but
have it inspected/repaired!
In case of internal overheating, the overheating safeguard will switch the heater off.
This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially) covering
the heater, obstructing the air intake and/or outlet grills or installing the heater too
close to a wall or something similar. When the overheating safeguard switches the
heater off, set the mode selector dial to '0' (off), unplug and allow the heater to cool
down. Remove and/or amend the cause of overheating and reuse the heater as
normal. If you cannot find a cause and overheating recurs, stop using the heater, and
take it in for inspection/repair.
Cleaning and Maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common
cause of overheating so these should be removed regularly. Switch off the heater,
remove the plug from the socket and allow the heater to cool down before cleaning or
carrying out maintenance work.
13