Seamaid 501023 Manuel D'installation page 5

IMPORTANT : This instruction manual includes essential information on the safety measures to be
implemented for installation and start -up. It is important to read these instructions before beginning
installation and start-up. Keep this manual for future reference.
Failure to comply with the instructions given by the manufacturer in this manual regarding
installation, operational start up and maintenance of the product exonerates the manufacturer or the
distributor from any liability for damages affecting pe rsons, the concerned product or the other
installations, and shall void the guarantee .
1. VERIFY THE CONTENT OF THE PACKING

Stainless Steel LED bollard ~12V

Grass plug

Connection box IP44

Manual of installation and maintenance
2. GENERAL CHARACTERISTICS
This bollard has been designed to be used outdoor. It is a Class III electric apparatus with very low
safety voltage ~12V.
This bollard complies with IP65 degree of protection and must be installed vertically to resist to rain or
water projection.
This bollard complies with international standards for lights, especially the EN 60598-2-7 standards,
lights for gardens.
3. INSTALLATION
For a correct installation, the power socket which feeds the installation bollard will have to possess a
device of protection by residual current with a maximal intensity of 30 mA.
This bollard will be only connected to a ~12V security transformer with double winding. Another type of
transformer is prohibited.
The power of this transformer will be always higher than the power of all projectors connected.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any
electric components which have been inserted or handled at locations other than its own premises.
4. ASSEMBLY

Before any operation, turn OFF the power supply to bulb

Connect the low voltage power cable in the bollard using the connection box supplied

Fix solidly the bollard using the fixations systems appropriate to the nature of the ground

For use on grass or land, use the supplied plug and screw it on the base of the bollard. It is
recommended to wet the ground to plant totally the plug.

Assure that the power supply voltage is only ~12V

Switch on the bollard
5. MAINTENANCE
This bollard does not require any type of maintenance work. In case of improperly working, please
contact our customer service or the customer service of our dealer.
6. OPERATION
This LED bollard is operating as a traditional incandescent lamp.
The driving mode is given by the On/Off interrupter in the electric panel.
An optional ~12V radio remote controller of the same brand can be installed.
The system offers 16 programs including 11 static colours and 5 automatic modes.
The control is made manually by short cuts of the current. Each fast cut of the current (less than 2
seconds) makes change the programs. After leaving the lamps OFF for over 10 seconds, switch ON
restarts from the last program used.
ENGLISH