Handicare SIMPLICITY Manuel D'installation page 21

b For multiple lift applications:
i Remove the red dipswitch protection cap
with a small screwdriver (Figure 55).
ii Set the dipswitches on the PCB on both
handsets to the same settings – note
that the next pair of handsets will require
the dipswitches to be set to a different
combination (see Figure 56).
iii Press and hold the red button on the
PCB (Figure 54) – a yellow LED will
illuminate on the PCB.
iv Press any button on one handset and
the yellow light will go out.
v Programming is complete.
5 Test that the handsets have programmed
correctly by pressing the up and down button
on each and check that the lift moves in the
corresponding direction.
Fitting the handset holder
Note: The handset MUST be fixed into the
holder by screwing through the holder into
the handset (Figure 57).
1 Fit the hand control holder to the wall in the
required position using the fixings supplied
(Figures 58 and 59).
Figure 55
Remote control handsets
Figure 57
Figure 58
HANDICARE SIMPLICITY INSTALLATION MANUAL 21
Figure 56
Figure 59