Handicare SIMPLICITY Manuel D'installation page 16

Fitting the seat
Note: Do not fully tighten any of the seat
bolts at this stage as the seat has not yet
been levelled.
6 Lay the seat on its back on the floor and
remove the seat base bolt and washer
(Figure 42).
7 Lift the seat (Figure 43) and position it on
to the seat stem.
8 Gently rotate the seat backwards and
forwards until the swivel locking peg locates.
9 Fully swivel the seat using the swivel levers.
10 Re-fit the seat base bolt and washer that you
removed in step 6 (Figure 44).
11 Swivel the seat back to the drive position
using the swivel levers.
12 Remove the drive toggle and link cables and
make the seat cable connections (Figure 45).
13 Fit the footplate chassis cover (Figure 46),
ensuring that all cables are positioned within
the cover.
Note: Ensure that no cables are pinched
or trapped when fitting the footplate
chassis cover.
14 Re-position the track as previously described
on page 8 with the feet against the stringer.
16 HANDICARE SIMPLICITY INSTALLATION MANUAL
Figure 42
Figure 43