Interpump Group VHT63 Série Mode D'emploi page 8

The manufacturer INTERPUMP GROUP S.p.A. – Via E. Fermi, 25 – 42049 S.ILARIO D'ENZA (RE) - Italy
DECLARES under sole responsibility that the equipment identified and described as follows :
Name : PUMP
Type : Reciprocating plunger pump for high pressure water
Trademark : INTERPUMP GROUP
Models : VHT6311 – VHT6313 – VHT6315
Complies with the requirements of the directives listed below and subsequent updates :
- Machinery Directive 2006/42/CE
- Directive 2011/65/EU – RoHS on the restriction of the use of certain hazardous substances in electrical
and electronic equipment.
The equipment does not contain more than the specified concentrations of restricted substances listed in Annex
II except for the applications exempted from the restriction listed in Annex III.
Standards applied : UNI EN ISO 12100:2010 - UNI EN 809:2000
The pump identified above meets all the essential safety and health protection requirements as listed in
section 1 of Annex I of the Machinery Directive :
1.1.2 - 1.1.3 - 1.1.5 - 1.3.1 - 1.3.2 - 1.3.3 - 1.3.4 - 1.5.4 - 1.5.5 - 1.6.1 - 1.7.1 - 1.7.2 - 1.7.4 - 1.7.4.1 - 1.7.4.2
and the relevant technical documentation has been compiled in accordance with Annex VII B.
In addition, the manufacturer undertakes to make available, following a reasoned request, a copy of the
relevant technical pump documentation in the manner and terms to be defined.
The pump should not be put into service until the plant to which the pump is to be incorporated has been
declared in accordance with the provisions of the relevant directives and/or standards.
Person authorised to compile the technical file :
Address: INTERPUMP GROUP S.p.A. – Via E. Fermi, 25 – 42049 S. ILARIO D'ENZA (RE) – Italy
Manager
Reggio Emilia, October/2017
DECLARATION OF INCORPORATION
(In accordance with Annex II of European Directive 2006/42/CE)
Name: Maurizio Novelli
Signature :
7