Sony CPJ-A300 Mode D'emploi page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Projecting (continued)
• Avoid exposing any
part of the IR receiver
to strong rays such as
direct sunlight or
inverter fluorescent
lamp rays or to
another infrared ray
source such as a
remote commander.
Doing so may cause
noise in the picture
and sound.
• Keep the mirror
clean. The dirty
mirror may not
reflect the infrared
rays to the IR receiver
properly.
• If the noise may
appear in the picture
or sound when using
the LASER LINK
system, connect the
projector and video
equipment using the
supplied A/V
connecting cable.
14
Projecting
-EN
3
Open the cover, and point the IR transmitter at the
mirror for the IR receiver.
The diagram illustrates the approximate area
covered by the infrared rays. Position the IR
transmitter and the IR receiver within the area.
: Signal flow
4
Start playback on the video equipment.
5
Adjust the angle of the mirror for the IR receiver so
that the picture and sound are optimum.
You can open the mirror up to 90 degrees and turn
it 360 degrees.
90˚
Max. 16 feet (5 m)
Mirror
360˚

Publicité

Chapitres

Table des Matières
loading

Table des Matières