Fleischmann 731474 Instructions De Service page 18

Short mode:
1. Input the CV to be programmed as address
2. Operate the directional reverse on the controller
3. Front light flashes two times in series per second
4. Input the value for this CV as address (for value 0 use
address 80)
5. Operate the directional reverse on the controller
6. Front light flashes one time per second
Input next CV and program it or terminate programming by swit-
ching off the track voltage.
Long mode:
Note, always to use address 80 if value 0 is desired!
1. Input hundreds' and tens' of the CV to be programmed (i.e.
for CV123 input 12)
2. Operate the directional reverse on the controller
3. Front light flashes two times in series per second
4. Input ones' of the CV to be programmed (i.e. for CV123
input 3)
5. Operate the directional reverse on the controller
6. Front light flashes three times in series per second
7. Input hundreds' and tens' of the value for this CV
8. Operate the directional reverse on the controller
9. Front light flashes four times in series per second
10. Input the ones' of the value for this CV
11. Operate the directional reverse on the controller
12. Front light flashes one time per second
Input next CV and program it or terminate programming by swit-
ching off the track voltage.
6.2 Programming
Station:
Attention!
The database of the Märklin**-Mobile Station contains only
Märklin**-locos.
To attach Fleischmann locos to the database, please use
either one of the universal numbers 36330 or 37962. Follow
the next steps to set them up:
Attach loco to database:
1. Control knob must be positioned on „0"
2. Press „ESC"-button
3. With control knob to menu item „New Loco"
4. Press control knob
5. With control knob to menu item „Database"
6. Press control knob
7. With control knob select one of the two universal numbers
(beginning with 36330 is recommended)
8. Press control knob
Set up the correct address:
1. Press „ESC"-button
2. With control knob to menu item „Change Loco"
3. Press control knob
4. Select menu item „Address"
5. Press control knob
6. Select address of the loco
7. Press control knob
If the loco does not drive now, delete it from the database:
1. Press „ESC"-button
2. With control knob to menu item „Delete Loco"
3. Press control knob
4. Press control knob again for confirmation
Then repeat the following steps:
„Attach loco to database" (1-8) und „Set up the correct address
(1-7) with number 37962. If there are still problems, delete the
loco from the database, again.
Then repeat the following steps:
„Attach loco to database" (1-8) but in step 5. select menu item
„Address" and in step 7. select the address of your loco. Search
the desired symbol by using the control knob and confirm by
pressing the control knob.
with Märklin**-Mobile
17