ADURO 9.7 Mode D'emploi page 39

If you experience problems lighting the fire or the fire dies after a short time, it can be due to the following
reasons:
•
The fire wood is not dry enough. The fire wood should have a moisture content of max. 18%.
•
There is a negative pressure in the house. See section 3.3.
•
The smoke outlet from the outside may be blocked from sooth. This can occur after chimney
sweeping. Control the smoke outlet.
•
The used amount of wood may have been too small. Therefore, the embers were too weak and cold
to light the next load of wood.
Use of dry wood of the right size is important to achieve optimum
combustion.
3.5 The first time a fire is lit
The wood burning stove is packed in recycling packaging. The wood from the packaging can be sawed into
smaller pieces and used the first few times a fire is lit. The plastic packaging must be disposed according to
national rules regarding disposal of waste.
During transportation, it may happen that the baffle plate in steel falls out of place. Therefore, before using
the stove, please make sure that the baffle plate is properly placed (on the hooks or fastened to the bolts
depending on the model) for optimum combustion and preventing soot on the glass.
The first few times the wood burning stove is used, there may be some smoke and unpleasant odours from
the wood burning stove, which is fairly normal. This is caused by the heat-resistant paint hardening. Make
sure there is sufficient ventilation during this stage. It is also important not to let the fire burn too fiercely the
first 2-3 times, so that the wood burning stove has time to expand slowly.
You should also be aware that the stove may make some clicking sounds as it heats up and cools down –
like pouring boiling water into a sink. These are caused by the great differences in temperature to which the
materials are being exposed.
During the first firing, which should be carried out using approximately 1 kg of
wood, the stoking door must be left slightly open and must not be closed until
the stove is cold. This is to prevent the sealing rope sticking to the stove.
3.6 Lighting a fire in the wood burning stove
The fire lighting method is very important for starting combustion quickly and efficiently.
1. Open the primary damper under the door and the secondary damper behind the door. The
illustration below shows the stove seen from the front with the dampers indicated.
2. Place a log of wood crosswise in the combustion chamber and put 2 firelighters close to the log.
Light the firelighters and quickly put a new log close to the firelighters and several small logs at an
angle above it. Air must be able to reach the firelighters, but the logs should be touching to "warm"
each other.
3. Keep the door approx. 1 cm ajar, until the glass is too hot to touch. Then close the door. When there
are distinct, visible flames and the fire has taken hold, close the primary air intake/damper (see
section 3.1.3).
39