Bluetooth Operation - Furrion DV1230 Manuel D'instructions

Operation

Bluetooth Operation

Pair DV1230 with your mobile phone
1. Activate Bluetooth mode on your mobile
device. Then press BT on the front panel
of DV1230 to enter pairing mode.
2. When DV1230 is detected by your mobile
phone, the device name FURRION
DV1230-XXXX (where X can be any
character from A-Z or number from 0-9)
is shown on your mobile phone.
3. Select the device name on your mobile
phone, then an input box will pop up,
asking you to input a password.
4. Input 0000 and confirm. Upon successful
pairing and connection, 'LINK OK' will
appear on the LCD of DV1230.
Note:
1. Some mobile phones support automatic
re-connection after first-time pairing
with DV1230. Some other mobile phones
may need you to select the device name
(FURRION DV1230-XXXX) from the list of
paired Bluetooth devices to confirm re-
connection.
2. In case of casual disconnection, select the
device name (FURRION DV1230-XXXX)
from the list of paired Bluetooth devices to
confirm re-connection.
Disconnect / unpair DV1230 from
your mobile phone
1. To disconnect:
On your mobile phone, select the
connected device name (FURRION
DV1230-XXXX) from the list of paired
Bluetooth devices and confirm
disconnection.
2. To unpair:
Press and hold BT on the front panel of
DV1230 for about 5 seconds to clear the
pairing information.
Operate your mobile phone via
Bluetooth
When the Bluetooth connection is ready, the
call you make or receive will be transferred
from your mobile phone to DV1230.
1. When connected: Use controls on your
mobile phone to switch sound output
between DV1230 and the mobile phone.
2. To dial a number with the remote control
of DV1230:
● Use number buttons 0-9 to enter a
telephone number.
* You can press CLEAR to cancel a wrong
input if necessary.
/
Press on the front panel (or
●
the remote control) to call out.
3. To redial a number:
/
Press on the front panel (or
●
the remote control) to show the last
dialed number on the LCD and call out.
4. To accept a call:
When there is an incoming call,
on the front panel (or
control) to accept the call.
5. To reject a call:
When there is an incoming call,
/
hold on the front panel (or
on the remote control) to reject the call.
6. To end a call:
During a call,
press and hold
the front panel (or
control) to end the call.
Note: When there is an incoming call, the
calling number will be displayed on the
screen of DV1230.
on
on
press
on the remote
press and
press
/ on
press on the remote
/
30