Set The Alarm; Reset The Unit - Furrion DV1230 Manuel D'instructions

Operation

Set the alarm

1. Press and hold
alarm clock and source settings.
2. Repeat the operations in clock setting to
set the alarm.
Two alarm sources are available for
selection: TUNER and USB.
● Press to turn on or off the set alarm.
When the alarm is set, the
on the LCD.
Select a preset EQ mode
Press and hold
SEL
EQ
equalizer curves: CINEMA, ROCK, CLASSIC,
FLAT, or EQ OFF.
Turn on / off LOUD mode
Press on the front panel once or more
SEL
EQ
to turn on / off LOUD mode.
Adjust the sound equalizer curves
1. Press on the front panel once or
SEL
EQ
more to select a sound equalizer curve:
VOL, BAS (without preset EQ), TRE (without
preset EQ), BAL, LOUD ON/OFF, LOC ON/
OFF, ST ON/OFF, BEEP ON/OFF, or SUB
ON/OFF.
2. Rotate the VOLUME -/+ knob on the front
panel to select a sound feature.
Select ZONE 1 / ZONE 2 / ZONE 3
Press and hold ZONE 1 / ZONE 2 / ZONE 3
to turn on or off the audio source in each of
the different areas where your speakers are
connected.
The corresponding zone number will be
displayed on the LCD once selected.
Note: ZONE 3 supports independent audio
output control.
19
once or more to enter
icon will stay
to select the preset music
● Press ZONE 3 to activate independent
audio selection mode.
The "ZONE 3" icon will flash on the LCD.
● Select the media source (DISC/USB, AM/
FM, BT, F AUX/R AUX, AV, HDMI, COAXIAL,
OPTICAL), then adjust the audio effect and
preset EQ independently.
● After setting ZONE 3 audio output, you
can press ZONE 3 again to switch back to
ZONE1/ZONE 2 audio output control mode
(ZONE 1 and ZONE 2 in the same group).
The "ZONE 3" icon will stop flashing.
− If ARC is selected as the media source
of ZONE 3 (ZONE 1/ZONE 2), the media
source of ZONE 1/ZONE2 (ZONE 3) can be
selected as DISC/USB, AM/FM, BT, F AUX,
R AUX, AV, or ARC.
− If AM/FM or BT is selected as the media
source of ZONE 3 (ZONE 1/ZONE 2), the
media source of ZONE 1/ZONE2 (ZONE
3) can be selected as DISC/USB, AM/FM,
BT,F AUX, R AUX, AV HDMI, COAXIAL,
OPTICAL, or ARC.
− If USB/DISC is selected as the media
source of ZONE 3 (ZONE 1/ZONE 2), the
media source of ZONE 1/ZONE2 (ZONE 3)
can be selected as AM/FM, BT, F AUX, R
AUX, or AV.

Reset the unit

In case of incorrect display, button failure, or
distorted sound, you can press RESET with a
sharp object such as a clip to reset the unit and
load its factory default settings.