Common Operation; Adjust Volume - Furrion DV1230 Manuel D'instructions

Operation

Common Operation

Turn the unit on or switch to standby
mode
Press to turn the unit on or switch to
standby mode.
Select a source
DISC / USB - Once a DVD or USB is inserted
into the unit, the unit will automatically
switch to the corresponding source. If a disc
has already been inserted and the unit is
playing from another source, you can press
DVD / USB to select DVD.
AM/FM - Press this button to scroll through
FM1, FM2, FM3, AM1, and AM2.
Press and hold this button once or more to select
the radio region: USA1, USA2, AUSTRALIA,
or EUROPE.
BT - Press this button to enable Bluetooth
connection.
AUX - Press this button to scroll through the
AUX inputs available for the unit.
F AUX - Connection on the front of the unit to
connect an external audio source.
R AUX - Connection on the rear of the unit,
normally used to connect TV sound input.
AV - Connection on the rear of the unit to
connect an external audio source.
HDMI - Connection on the front of the unit.
COAXIAL - Connection on the rear of the unit.
OPTICAL - Connection on the rear of the unit.
HDMI OUT (ARC) - Connection on the rear
of the unit, used to connect a TV with Audio
Return Channel function. Make sure the ARC
function of the TV is on.
● For details on setting and operating your TV,
refer to the instruction manual for the TV.
About Audio Return Channel (ARC)
ARC allows audio signals to travel both ways
under HDMI Control. If you connect a TV that
supports HDMI Control and ARC to the unit
with a single HDMI cable, you can output video/
audio to the TV or input TV audio to the unit. In
case noises are produced from the speakers
connected to the unit because TV audio signals
input to the unit via ARC are not supported by
the unit, use the TV's speakers.

Adjust volume

Rotate the VOLUME -/+ knob clockwise to
increase volume, or rotate counterclockwise
to decrease volume.
Mute
1. Press MUTE to mute sound output in any
source mode.
'MUTE' will be displayed on the screen.
2. Press MUTE again to resume.
Display and set the clock
1. To display the clock on the LCD screen,
press CLOCK on the remote control.
In standby mode, the clock time will stay on
the LCD.
2. To adjust or set the clock, press
front panel once or more to enter clock setup
mode.
Press
/
and minute setting.
Rotate the VOLUME -/+ knob to adjust the
hour / minute.
The time on the clock is set automatically after a
few seconds of inactivity.
on the
SEL
EQ
to switch between hour
18