Quick Reference Guide; General Operation - Furrion DV1230 Manuel D'instructions

Operation

Quick Reference Guide

Power on/off, switch
to standby mode
Mute
Select a source
Adjust volume
Select a feature /
setting
Select a preset EQ
Set clock
Set alarm
Turn alarm on/off
Adjust brightness
Select speakers
Reset
15

General Operation

Press to turn the unit on or enter standby mode.
Press and hold to turn the unit off.
Press MUTE to mute sound. The
Press MUTE again to restore the sound.
Press DISC/USB, AM/FM, AUX, BT to select Disc (with a disc loaded), USB (with
a USB storage device connected), AM/FM, AUX, or BT.
VOLUME -/+ knob
Rotate the
1. Press SEL once or more to select VOL, BAS (without EQ preset), TRE
EQ
(without EQ preset), BAL, LOUD ON/OFF, LOC ON/OFF, ST ON/OFF, BEEP ON/
OFF, SUB ON/OFF, or CLOCK.
VOLUME -/+ knob
2. Rotate the
SEL
Press and hold once or more to select CINEMA, ROCK CLASSIC, FLAT, or
EQ
EQ OFF.
1. Press SEL on the front panel once or more (or press and hold CLOCK on the
EQ
remote control) to enter clock setup mode.
VOLUME -/+ knob
2. Rotate the
3. Press / to enter minute setting.
VOLUME -/+ knob
4. Rotate the
The time on the clock is set automatically after a few seconds of inactivity.
Press and hold once or more to enter alarm clock and source settings.
Repeat the operations in clock setting to set the alarm.
Two alarm sources are available for selection: TUNER and USB.
Press to turn on or off the set alarm.
When the alarm is set, the
Press once or more to select a brightness level for the front panel: LOW,
MIDDLE or HIGH.
Press and hold ZONE 1, ZONE 2 or ZONE 3 to select speaker output. The
corresponding zone number will be displayed on the LCD once selected.
Press RESET with a sharp object to reset the unit and load its factory default
settings.
icon flashes on the display.
to adjust volume.
to select a feature / setting.
to adjust the hour.
to adjust the minute.
icon will stay on the LCD.