Radio Operation - Furrion DV1230 Manuel D'instructions

Operation

Radio Operation

Select a radio region
In radio mode, press and hold AM/FM to
select your desired radio region: USA1/USA2/
AUSTRALIA/EUROPE.
Select AM/FM band
In radio mode, press AM/FM once or more
to select your desired radio band: FM1, FM2,
FM3, AM1, or AM2.
The selected band will be displayed on the
front panel.
Tune to / search for radio stations
In radio mode:
● Press and hold
panel (or /
control) to automatically search down/up
for an available station from the current
frequency.
● Press /
(or / on the remote control)
to manually search up or down for
your desired station from the current
frequency.
Use the / APS button
In radio mode:
1. Press and hold
APS on the remote control) to search
for radio frequencies with sufficient
signal strength (starting from the lowest
frequency and ending until the search
cycle is finished).
Then the 6 strongest stations are preset
to the memory bank of the corresponding
preset number. The AS operation is
implemented in each bank of the selected
band. When the AS operation is finished,
radio broadcast will resume on M1. (A total
of 3x6 stations for FM and 2x6 stations for
AM can be stored.)
/ on the front
on the remote
on the front panel
on the front panel (or
2. Press on the front panel (or APS on the
remote control) to search for each preset
radio station starting from M1. When the
field strength level is above the threshold
of the stop level, the radio holds at that
preset number for a few seconds, and
then searches again. The search stops on
M1 when the search cycle is finished.
NOTE:
On FM band, FM1, FM2, FM3 is checked
once at a time.
On AM band, AM1, AM2 is checked once
at a time.
Use the preset number button (1-6)
In radio mode:
1. To store the current frequency on the
current band, press and hold any one of
the six preset number buttons (1-6).
2. To recall the preset memory on the
current band, press one of the preset
buttons (1-6).
Switch between STEREO/MONO
Press on the front panel (or ST on the
SEL
EQ
remote control) once or more to select ST ON
or ST OFF mode in FM mode.
Use the LOC ON / OFF function
1. In radio mode, when the signals of the
distant radio stations are very weak and
the reception is poor during tuning, press
on the front panel (or LOC on the
SEL
EQ
remote control) once or more to select
LOC OFF mode, and then tune again for
the distant radio stations.
2. In radio mode, too strong signals from
the local radio stations may lead to
interference. You can press
front panel (or LOC on the remote control)
once or more to select LOC ON mode,
and then re-tune to the local stations if
required.
on the
SEL
EQ
20