Table des Matières
Publicité
ENGLISH
BATTERY OPERATED HYDRAULIC CRIMPING TOOL
B35-45D ; B35-45DA
1. GENERAL CHARACTERISTICS
28
TOOL TYPE:
Application range:
suitable for installing electrical compression connectors
Crimping force
kN (sh ton):
Rated operating pressure bar (psi):
Dimensions LxWxH
mm (inches):
Weight with battery
kg (lbs):
67
Motor
Volt DC:
16
Battery type CB9620H
Volt / Ah:
Battery charger supply
Volt / Hz:
350
Recommended oil:
AGIP ARNICA 22 or ESSO INVAROL EP22 or equivalent.
600
Safety:
the tool is equipped with a maximum pressure valve.
Operating temperature:
Acoustic Noise (Directive 2006/42/EC, annexe 1, point 1.7.4.2 letter u)
– The weighted continuous acoustic pressure level equivalent
A at the work place L
is equal to ..............................................................................66,8 dB (A)
pA
– The maximum value of the weighted acoustic displacement
25
pressure C at the work place L
is ......................................................................< 130 dB (C)
22
pCPeak
– The acoustic power level emitted by the machine
L
is equal to ................................................................................................................75 dB (A)
WA
Risks due to vibration (Directive 2006/42/EC, annexe 1, point 2.2.1.1)
Tests carried out in compliance with the indications contained in UNI ENV 25349 and UNI EN 28662
26
part 1
Standards, and under operating conditions much more severe than those normally found,
st
23
certify that the weighted root mean square in frequency of the acceleration the upper limbs
are exposed to for each biodynamic reference axis does not exceed 2.5 m/sec
21
The part references "B35-45D ; B35-45DA" include the following:
– Basic tool complete with battery
– Spare battery
– Battery charger complete with CBA96-144 adapter
– Plastic carrying case VAL P22
24
The tool can be held in one hand while positioning the connector with the other.
Residual battery capacity level is automatically displayed after every cycle.
TIGHTENING TORQUE
COUPLE DE SERRAGE
DREHMOMENT
PAR DE TORSION
37
COPPIA DI SERRAGGIO
8 Nm (5.9 lbf ft)
B35-45D
B35-45DA
36
69
68
for conductors up to 150 mm
(300 MCM)
2
35 (4)
78
390 (5,600)
342 x 108 x 66 (13.4 x 4.2 x 2.6)
2,1 (4.6)
64
72
9.6
9.6 / 2.0 Ni-MH
75
220 - 240 / 50 - 60
120 / 50 - 60
65
67
66
-15°C to +40°C (+5°F to +104°F)
360
71
70
35
33
42
.
2
1
34
24
26
31
18
19
8
30
27
17
310
6
62
77
63
57
45
500
32
3
32
TABLE 2 - TABLEAU 2 - TABELLE 2
- TABLA 2 - TAVOLA 2
4
19
18
10
9
11
7
210
8
9
16
11
220
17
21
400
15
29
300
100
1
250
20
15
Publicité
Table des Matières
