Skil RT1323-00 Guide D'utilisation page 17

"Live Tool Indicator" Light (Fig . 8)
Your router also has a "Live Tool Indicator"
green light, located on the motor housing top
cap where the power cord enters the motor
housing. This green light is always on when
router motor is plugged into power source.
Edge Guide (Fig . 9)
The Fixed-Base Router comes with an edge
guide. This edge guide can be used as an
aid in routing applications such as decorative
edging, straight edge planning and trimming,
grooving, dadoing, and slotting.
To assemble the edge guide, insert two edge-
guide rods into the holes on the edge guide,
and then use two screws (included) to lock the
edge-guide rods in place.
To attach the edge guide to the fixed base,
simply insert the edge guide rods into the edge
guide mounting slots either from the left or
the right. Adjust the edge guide to the desired
position. Secure the edge guide by turning the
edge guide levers toward two handles.
NOTICE: If the inner screws wear down or
become loose, to tighten the inner screws:
Pull the lever up to strip from the hex nut of
•
the inner screw, turn the edge-guide lever
clockwise (for the right edge guide lever)
or counterclockwise (for the left edge guide
lever) then push the lever down (Fig. 10).
Turn the edge-guide lever counterclockwise
•
(for the right edge guide lever) or clockwise
(for the left edge guide lever) to secure the
edge guide rod.
Fig. 8
Fig. 9
Edge Guide
Lever
Fig. 10
Hex Nut of
Inner Screw
"Live Tool
Indicator" Light
Edge Guide
Rods
Edge Guide
Screws
Hex Nut of
Inner Screw
17