Skil RT1323-00 Guide D'utilisation page 18

Electronic Variable Speed Control
The electronic variable-speed control feature
allows the router motor speed to be matched
to cutter size and material hardness for an
improved finish and extended bit life.
Speed changes are made by rotating the
speed control dial to the "LEFT" to increase
the speed, and to the "RIGHT" to decrease
the speed as indicated on the dial, numbered
1 through 6 (Fig. 11) .The speed may be
changed while the router is "ON", but do
not change the speed when the cutter bit is
contacting the workpiece.
WARNING
contacting the workpiece, as this will cause excessive vibration.
Your router motor top cap has a "Variable Speed Selection Chart" located above the "ON/OFF"
toggle switch to help you determine the correct speed for the cutter bit being used.
WARNING
Cutting-Bit Diameter
UP to 1in.(25mm)
1 1/4-in. to 2-in. (30-50mm)
2 1/4-in. to 2 1/2-in. (55-65 mm)
3-in. to 3 1/2-in. (75-90mm)
Reduce the speed when using extra-large bits (cutting diameter of 1 inch or greater), or heavy
cutting bits. Changing the rate of feed can also improve the quality of the cut.
DIAL SETTING
1
2
3
4
5
6
The speed charts above indicate the relationship between speed settings and the cutting
application. Exact settings are determined by operator experience and reference, and also by
recommendations made by manufacturers of cutter bits.
18
Do not change the speed
when the cutter bit is
Before operating your router follow all safety instructions in this manual.
Failure to do so could result in serious personal injury.
Variable Speed Selection Chart
Never exceed these bit speeds
RPM
10,000
13,000
16,000
19,000
22,000
25,000
Fig. 11
Max.Speed
5-6
3-4
2-3
1-2
APPLICATION
Non-ferrous metal, hardwoods, larger
diameter cutter bits
Softwoods, plastics, countertops, smaller
diameter cutter bits
Variable
Speed Dial