Makita HR2631F Manuel D'instruction page 8

Insert the bit into the tool. Turn the bit and push it in until
it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
1
015255
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
Bit angle
(when chipping, scaling or demolishing)
015345
The bit can be secured at the desired angle. To change
the bit angle, rotate the action mode changing knob to
the O symbol. Turn the bit to the desired angle.
015346
Rotate the action mode changing knob to the
Then make sure that the bit is securely held in place by
turning it slightly.
Depth gauge
The depth gauge is convenient for drilling holes of
uniform depth.
1. Bit
2. Chuck cover
2
1. Action mode
changing knob
1
3
1
015347
Press the lock button on the grip base in the direction of
arrow shown in the figure and with the lock button being
pressed insert the depth gauge into the hex. hole in the
grip base.
015348
At this time, the depth gauge needs to be inserted so that
its toothed side is directed to the toothed side of hex hole
marking on the grip base as shown in the figure.
015349
Adjust the depth gauge to the desired depth by moving it
back and forth while pressing the lock button. After the
adjustment, release the lock button to lock the depth gauge.
symbol.
015350
NOTE:
Inserting the depth gauge with its toothed side not
•
directed to the toothed side of hex hole marking on
the grip base as shown in the figure does not allow
the depth gauge to be locked.
8
2
1
2
1
2
1
1. Grip base
2. Lock button
3. Depth gauge
1. Toothed side of
hex hole
marking on the
grip base
2. Toothed side of
the depth gauge
1. Lock button
1. Toothed side of
hex hole
marking on the
grip base
2. Toothed side of
the depth gauge