Residual Dangers Information; Failures, Malfunctions Or Other Inconveniences - Reverberi KIARA-TEC Manuel D'utilisation Et Entretien

3.2

RESIDUAL DANGERS INFORMATION

RESIDUAL DANGERS AND SIGNALS
To highlight to the user, to those exposed and to the authorized personnel all the residual risks to which attention must
be paid, it was decided to affix to the machine standardized symbols highlighted in the following pages.
The dangers to which it could not apply a total protection, because it would make the machine difficult to use,
inhibiting their intended use, are as follows:
1
Electrical dangers inside the control panel or any derivations of the unit.
Thermal dangers resulting from the contact of the user's arms when the respective electrical
resistance is operating.
2
4

FAILURES, MALFUNCTIONS OR OTHER INCONVENIENCES

In case of failures, malfunctions or other problems not covered in this U.M.M., call the manufacturer directly. The
address is as follows.
Tel. +39 (0) 522 875159
Any work on the machine, determined by a malfunction, must necessarily be performed by
In case of replacements of equipment parts, use original spare parts, to avoid causing
Each cleaning, checking and / or maintenance must be performed by authorized
personnel and authorized to do so in compliance with the requirements given in
KIARA-TEC /manuale di istruzioni-IT/ Rev.02/08.07.14
REVERBERI ARNALDO S.R.L.
Via Don L. Sturzo, 6 – 42021 BARCO di Bibbiano (RE) – ITALIA
Fax.+39 (0) 522 875579
variations in performance and / or reduce the level of safety
e-mail: reverberisrl@gmail.com
qualified personnel.
this U.M.M.
27