Environmental Conditions Allowed; Electromagnetic Compatibility - Reverberi KIARA-TEC Manuel D'utilisation Et Entretien

Are not covered by the warranty the damaged parts for transport / shock for bad or improper installation / use, through
neglect or misuse, tampering by unauthorized persons, damages weather or other natural events or other causes not
dependent on REVERBERI, supplies and / or subjected to wear / low.
Further or other claims for damages, in addition to those provided by law, are excluded.
The manufacturer will charge the cost of repair if the returned product is not covered under warranty.
Interventions for alleged defects or casual checking shall be borne by the customer.
Any repair of transport to and from the "Technical Assistance Centre" of BARCO di Bibbiano (RE) is done at the expense
and responsibility of the customer.
The technical staff, when called to repair, will be sent in time only compatible with the business needs of the manufacturer.
Any use bans imposed by the Health Authority or by other competent bodies, do not entitle the buyer to demand the
surrender or to ask for damages.
Any difference on the exterior colour or colour effects of the various parts making up the unit are not considered defects:
the differences may be e.g. due to the manual workers.
The inability to ensure substitutability of parts that make up the set with pieces from standard / freshmen / supplies
purchased specifically different and not as a replacement is not considered a defect.
In case of repair / replacement of defective parts or replacement of the equipment during the warranty period, the warranty
remains unchanged: it always starts from the original date of purchase of the unit.
As nothere reported The Terms and Conditions listed on the commercial documentation / sales catalogue in force at the
time of purchase remain valid.

2.3 ENVIRONMENTAL CONDITIONS ALLOWED

TEMPERATURE, HUMIDITY AND ALTITUDE
See Paragraph in particular

2.4 ELECTROMAGNETIC COMPATIBILITY

Install the unit where electromagnetic interference comply with the limits permitted by the rules and with the
presence of electric and electronic equipment.
RADIATION EXPOSURE
The appliance is not intended to be used to direct exposure to:
- Non-ionizing radiation of the sun, being the same to be placed indoor and / or repaired
- X-ray radiation, microwave radiation, laser radiation, etc...
In the event that, in the environment where the unit is placed, there is a risk of radiation directly on it, specific measures to
protect exposed areas must be taken by the purchaser.USE IN EXPLOSIVE ENVIRONMENT
The device cannot be used in any way in the environment where there is a risk of explosion or in a potentially explosive
environment.
IT IS FORBIDDEN TO USE THE EQUIPMENT IN EXPLOSIVE ENVIRONMENTS SUCH OR
CONSIDERED.
KIARA-TEC /manuale di istruzioni-IT/ Rev.02/08.07.14
24