Warranties And Liability; Warranties Conditions - Reverberi KIARA-TEC Manuel D'utilisation Et Entretien

2.1 WARRANTIES AND LIABILITY

The MANUFACTURER ASSUMES NO LIABILITY FOR DAMAGES CAUSED ON THEMACHINE, ON THINGS,
ANIMALS AND / OR PERSONS, MAKING ANY KIND OFWARRANTY INVALIDATE IMMEDIATELY IF:

THE INSTALLATION OF THE APPLIANCE IS NOT DONE BY QUALIFIED

PERSONNEL IN ACCORDANCE WITH THE RULES AND MAY BE REPORTED ASIN THE DECLARATION OF
CONFORMITY

THE START UP OF THE EQUIPMENT IS NOT PERFORMED BY A QUALIFIED

QUALIFIED PERSONNEL AND / OR USER NOT COMPLY WITH THE INSTRUCTIONS GIVEN IN THIS USER AND
MAINTENANCE MANUAL OR AS RESULT OF ANY OPERATION NO SPECIFICALLY DESCRIBED.

VERIFY CAREFULLY DURING THE READING OF U.M.M. THE CORRESPONDENCE WITH THE PARTS OF THE
EQUIPMENT, CHECKING:

THE PARTS HAVE NOT BEEN DAMAGED DURING THE TRANSPORTATION AND HAVE BEEN
DELIVERED INTEGRA,

THERE ARE ALL THE SAFETY SYMBOLS.
DO NOT PROCEED TO USE THE WASHING MACHINE IF ALL ITEMS DESCRIBED ABOVE DO NOT EXIST:

THE MANUFACTURER ASSUMES NO RESPONSABILITY FOR DAMAGES CAUSED TO THE SAME DEVICE ON
PEOPLE, ANIMALS AND / OR PROPERTY, IF ANY ANOMALIES IS NOT REPORTED WITHIN 30 DAYS OF
RECEIPT OF GOOD TO MANUFACTURER. IN THESE CASES ANY TYPE OF WARRANTY BECOME INVALID
AUTOMATICALLY.

TO COMPLY WITH THE TRACEABILITY OF THE WASHING MACHINE ANY CHANGE OF ADDRESS OF THE
SAME MACHINE MUST BE COMMUNICATED TO THE MANUFACTURER / DEALER.
ANY CHANGES MADE ON ITS DEVICE or safety devices, WHICH MAY AFFECT THE FUNCTIONS
PROVIDED BY THE MANUFACTURER and the risks of the risk analysis, included in the "Technical Construction
File",
WILL BE FULL RESPONSIBILITY OF THE RUN. AS CHANGE IS MEANT ALSO THE FAILURE OF THE
INSTRUCTIONS, REPRESENTATIONS AND EFFORT NONCONFORMING AND THE USE OF PARTS
ORIGINAL.
Any change, even if not substantial, must be communicated by registered post and also approved by the
MANUFACTURER, THAT will approve THE CHANGES only if, such amendment, shall not constitute implementations
of risk analysis AND THE risks of the machine.
Any change made without notice to the MANUFACTURER, will constitute CANCELLATION OF the "CE"
Declaration of Conformity, making void any warranty and guarantee by the same.
The manufacturer is not responsible for:
•
the placement of a protection mechanisms against overcurrent for power conductors of the electrical
equipment, which must be placed upstream of the apparatus and duly reported
•
the installation of a power plug to be placed between the electrical panel and the electrical appliance
in place of the existing installation.

2.2 WARRANTIES CONDITIONS

This appliance is guaranteed for one year (12 months) from the date of purchase, on the whole territory of the
European Union; the date of the delivery note / invoice will be the authentication.
The device is used for professional use.
During this period, the manufacturer will repair or replace for free those pieces that, at its own sole discretion, were to
be originally defective, with only the reimbursement of travel expenses incurred by the technicians of the "Service
Centre", at doorstep or totally free if the equipment is delivered to BARCO di Bibbiano (RE).
Defective parts replaced become the property of the manufacturer.
If the defect is not repaired, the manufacturer may avoid the termination of the contract by the customer by offering
free replacement of the property.
KIARA-TEC /manuale di istruzioni-IT/ Rev.02/08.07.14
NOT
.
23