ILLUMINATION IN THE WORKPLACE
The environment in which the Kiara-Tec depurator is installed must meet the requirements listed on the Directive 89/654/EEC
concerning the workplace and the requirements of the RULES FORCE THE INSTALLATION SITE.
Proper lighting can, in some cases, avoid or limit an injury to the operator.
2.5
REQUIREMENTS OF THE LOCAL WHERE THE EQUIPMENT IS INSTALLED.
THE LOCAL SHOULD:
• be free of debris and / or residues of various kinds of flammable or potentially dangerous operation;
• provide a specific room for washing, away from the patient.
• have doors (accesses) appropriate to the size of the machine, ensure a suitable floor for the mass flow of the
machine, ensure a perfectly level floor, be free, at the area of installation, strong drafts or substantial temperature
changes;
• ensure good ventilation and air exchange with the provision of specific natural ventilation openings.
2.6
USE NOT PERMITTED
it is not allowed:
• THE USE of the machine if you have not INSTALLED in accordance with APPLICABLE RULES and BY AUTHORIZED
PERSONNEL,
• the use of the appliance by USERS not authorized by the superior role (or employer),
• the use of the appliance by USERS not trained to manage it,
• the use the equipment for purposes other than those expected and stated in the Declaration of Conformity,
• the use the equipment in environments with explosive atmosphere or where there are similar risks,
• elaborate or otherwise alter the unit cycles and performance
• use or use accessories other than the original operation,
• use replacement parts other than original
• alter the electrical system and safety devices connected to them,
• NOT TO COMPLY WITH THE INSTRUCTIONS, THE OBLIGATIONS AND PROHIBITIONS CONTAINED IN THIS MANUAL
AND ON THE UNIT ITSELF.
3
RECOMMENDATIONS AND GENERAL SAFETY
• The user is responsible for installation, proper use and maintenance of the Kiara-Tec depurator in accordance with the
instructions in this manual. If necessary, contact your local Technical Support.
• The Kiara-Tec depurator should not be used with flammable gases or vapors.
• Do not remove the identification number or any other labels from the serial number
• To prevent electrical short circuits, do not spill water or other liquids on the machine.
• Turn off the machine and unplug the power cord before inspecting, make operations, maintenance or repairs .
• Keep the original packaging carefully for any transport.
• The repairs should be made by individuals authorized by the manufacturer and
using only original parts.
Close the water inlet valve at the end of work (at end of day). Remember to open the tap again to return to work.
In case of transport:
• Use the original packaging or other suitable packaging.
• Use a reliable transporter
KIARA-TEC /manuale di istruzioni-IT/ Rev.02/08.07.14
.
25