Devices For Personal Protection; Conduct Of Machine By User - Reverberi KIARA-TEC Manuel D'utilisation Et Entretien

Any intervention on, determined by a malfunction, must mandatory be performed by
qualified personnel to do so.
In case of replacements of equipment parts, use original spare parts, to avoid causing
variations in performance and / or reduce the level of safety.
Each cleaning, checking and / or maintenance must be performed by authorized personnel
and authorized to do so in accordance with the requirements described in this U.M.M.
Failure to follow the instructions in this manual
may cause danger to the user.

3.0 DEVICES FOR PERSONAL PROTECTION

TO BE USED TO PREVENT THE ONSET OF RESIDUAL RISKS
According to legal requirements dictated by the regulations on this subject it is the duty of Head of Hygiene and Safety
to analyse the potential risks people are exposed to and to wear appropriate Personal Protective Equipment (P.P.E.) in the
Studio where the equipment is installed. Regardless of the risk analysis of Hygiene and Safety Manager, in all cases mentioned
in this Section are shown the MANDATORY P.P.E. that the exposed personnel must use while approaching the machine. The
use of additional D.P.I. is at the discretion of the Head of the Hygiene and Safety in the Studio where the equipment is installed.
Use:
1. safety shoes to ensure a sufficient level of electrical / mechanical isolation /
2. flame retardant protective clothing.
3. appropriate gloves
EMERGENCY STOP Kiara-Tec
In case of emergency there is a need to stop THE equipment the operator must take prompt action on the connection socket /
plug off, grabbing the plug WITHOUT pulling the cable. In this regard it should be noted that the plug must always be free of
any material or furniture and always visible.

3.1 CONDUCT OF MACHINE BY USER

The user's tasks are:
• monitor the operation of the appliance, acting promptly in case of malfunctions;
• check the constancy of performance and integrity of the devices used and promptly shut down the device in case of
malfunctions.
It is FORBIDDEN to leave the unit without first having switched it off at the end of the work
The intervention of the user will always be subject to compliance with the symbols placed
on the machine and the requirements dictated by this U.M.M.
KIARA-TEC /manuale di istruzioni-IT/ Rev.02/08.07.14
26