BH FITNESS G2342 Instructions De Montage Et Utilisation page 14

Fig 1 Parts list
(A) Main body.
(B) Main post.
(56) Handlebar tube.
(43) Monitor.
(D) Front stabiliser bar with wheels.
(E) Rear stabiliser
adjustable feet.
(28) Left footrest.
(93) Right footrest.
(92) Top focus bar, right.
(60) Bottom post cove.r
(65) Rear post cover.
(64) Front post cover.
(12) Front knuckle joint cover.
(14) Rear knuckle joint cover.
(5) Top focus bar, left.
(103) Knob.
Fig 2 Screws and fasteners
(15) Flat washer M8.
(17) Spring washer M8.
(23) Flat washer M10.
(25) Screw M-4x20.
(36) Screw M-5x16.
(49) Corrugated washer M8.
(51) Allen screw M-8x72.
(59) Self-locking nuts M8.
(70) Screw M-8x20.
Allen key 5 mm.
Allen key 6 mm.
Box spanner with star screwdriver.
2. FITTING THE STABILISER
BARS.-
Bring the front stabiliser bar with
wheels (D) to the main body (A)
positioning the wheels at the front of
the unit, Fig.3, insert screws (51), fit the
spring washers (17) and the corrugated
washers (49). Use the 5 mm Allen key
to tighten securely.
Take the rear stabiliser bar with
adjustable feet (E), Fig.4, insert the
bolts (70); fit the washers (15), and the
nuts (59) and tighten securely.
3. FITTING THE FOOTRESTS.-
bar with
Next, remove the knobs (26), the flat
washers (23) and the screws (27) and
position the left footrest (28) (marked
with the letter "L") on top of the unit's
left foot (30), Fig.5, (left and right refers
to the user's position doing exercise)
refit the screws (27), the washers (23)
and the knobs (26) removed previously
and tighten securely.
Next, position the right footrest (93)
(marked with the letter "R") on top of
the right foot (96), refit the screws (27),
the washers (23) and the knobs (26)
removed
securely.
4. FITTING THE BOTTOM
POST COVER.-
Take the main post (B) and insert the
bottom post cover (60) in the direction
of the arrow, Fig.6.
5. FITTING THE MAIN POST.-
Once the bottom post cover is fitted,
remove the screws (16) and washers
(17) and (49) from the bottom of the
main post (B).
Bring the main post (B) up to boss on
the main body (A), Fig.7.
Take the tip of the tension cable (62),
sticking out of the bottom of the main
post (B) and connect it to the tension
support (61), as shown in Fig.7A.
Plug connector (53), coming out of the
main post, into connector (84), coming
out of the boss on the main body (A),
Fig.7A.
14
previously and tighten