dji MAVIC MINI Mode D'emploi page 3

EN
Disclaimer and Warning
Please read this entire document and all safe and lawful practices DJI
before use. Failure to read and follow instructions and warnings may result in serious injury to
yourself or others, damage to your DJI product, or damage to other objects in the vicinity. By
using this product, you hereby signify that you have read this disclaimer and warning carefully
and that you understand and agree to abide by the terms and conditions herein. You agree
that you are solely responsible for your own conduct while using this product, and for any
consequences thereof. DJI accepts no liability for damage, injury or any legal responsibility
incurred directly or indirectly from the use of this product.
This document and all other collateral documents are subject to change at the sole discretion of
DJI.
Introduction
The MAVIC Mini 360° Propeller Guard is used to effectively protect people and objects from
TM
the aircraft's propellers during use.
Installation
Make sure all frame arms are unfolded before installing the propeller guard. DO NOT fold the
frame arms with the propeller guard installed.
1. Release the locks on the underside of the propeller guard.
2. Rotate the propellers so that they are positioned directly above the frame arms.
3. Check the mark on the locks of the propeller guard and make sure they are marked FL (Front
Left) and BL (Back Left). Insert the front and rear frame arms of the aircraft's left side through
the open side of the propeller guard and into the corresponding mounting hole. First tilt the
front frame arm to help the landing gear pass through the mounting hole.
4. Make sure the frame arms are properly positioned in the mounting holes and close the locks.
A clicking sound indicates the lock is properly secured.
5. Repeat the steps above to install the propeller guard on the right side. Note that the mark will
be FR (Front Right) and BR (Back Right) for this side.
• The weight of the aircraft exceeds 250 g after the Mavic Mini 360° Propeller Guard is
installed. Make sure you understand and comply with the local laws and regulations
and, if required, have obtained corresponding approval and clearance from the related
government agencies before flight.
• After installing the propeller guards, hover the aircraft until DJI Fly indicates that the
payload has been detected, and the payload mode is enabled. If the status of the
payload mode in DJI Fly does not match the actual situation, turn it on or off manually in
the app.
• After installing the propeller guards, the maximum flight speed (no wind) is limited to 18
mph (29 kph), and the aircraft's max service ceiling above sea level is 1500 m. Maintain
visual line of sight of your aircraft even when using the propeller guards. To ensure flight
safety, the flight height will be limited to no more than 120 m, and the distance is no more
than 100 m.
Specifications
Weight (one side)
Radius
Installation Circumference
2
23.1 g
71 mm
318 × 267 × 66 mm
TM provided carefully