Ego Power+ BA1400T Manuel De L'utilisateur page 7

NOTICE:
This battery pack is equipped with an advanced
self-maintenance function to extend the battery life.
Depending on the battery charge,it will automatically
performa self-discharge operation after one month of
storage. After this self-maintenance, the battery pack
will enter sleep mode and maintain 30% of its charge
capacity. If stored for a month or longer, fully recharge the
battery before the next use. (Not applicable to BA2240T
which is equipped with other advanced technology to
extend the battery life.)
It is not necessary to run down the battery pack charge
before recharging. The Lithium-Ion battery can be
charged at any time and will not develop a "memory"
when charged after only a partial discharge. Use the
power indicator to determine when the battery pack
needs to be recharged.
HOW TO CHARGE THE BATTERY PACK
Follow the instructions in the Operator's Manual for the
EGO CH5500E Rapid Charger or CH2100E Charger.
TO ATTACH AND DETACH THE BATTERY PACK
Follow the instructions in the Operator's Manual for the
individual EGO product.
MAINTENANCE
WARNING: To avoid serious personal injury,
always remove the battery pack from the tool when
changing accessories, cleaning or performing any
maintenance.
WARNING:
When servicing, use only identical EGO
replacement parts. Use of any other parts may create a
hazard or cause product damage.
WARNING: It is not recommended to use
compressed dry air as a cleaning method for the battery
pack. If cleaning with compressed air is the only method
to apply, always wear safety goggles or safety glasses
with side shields. If the operation is dusty, also wear a
dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean clothes to remove dirt, dust, oil, grease, etc.
56 VOLT BATTERY — BA1400T/BA2240T/BA2800T/BA4200T/BA5600T
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating oils,
etc. come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in
serious personal injury.
WARNING:
TO REDUCE THE RISK OF FIRE,
PERSONAL INJURY, AND PRODUCT DAMAGE DUE TO A
SHORT CIRCUIT, NEVER IMMERSE YOUR TOOL, BATTERY
PACK OR CHARGER IN FLUID OR ALLOW A FLUID TO FLOW
INSIDE THEM. CORROSIVE OR CONDUCTIVE FLUIDS, SUCH
AS SEAWATER, CERTAIN INDUSTRIAL CHEMICALS, AND
BLEACH OR BLEACH CONTAINING PRODUCTS, ETC., CAN
CAUSE A SHORT CIRCUIT.
BATTERIES
The battery pack is equipped with Lithium-Ion
rechargeable batteries. The duration of use from each
charge will depend on the type of work performed.
The batteries in this tool have been designed to provide
maximum trouble-free life. Like all batteries, they will
eventually wear out.
Do not disassemble the battery pack or attempt to replace
the batteries. Handling of the batteries, especially when
wearing rings and jewelry could result in a serious burn.
To obtain the longest possible battery life, read and
understand the operator's manual.
It is good practice to unplug the charger and remove
the Lithium-Ion battery pack when not in use.
For Lithium-Ion battery pack storage longer than
30 days:
Store the Lithium-Ion battery pack where the temperature
is below 26°C and free of moisture.
Store Lithium-Ion battery packs in a 30%-50%
charged condition.
Every six months of storage, fully charge the Lithium-
Ion battery pack.
Exterior may be cleaned with a cloth or soft non-
metallic brush.
EN
7