Ego Power+ BA1400T Manuel De L'utilisateur page 6

DESCRIPTION
EN
KNOW YOUR LITHIUM-ION BATTERY PACK (Fig. A)
1. Cooling Air Port
2. Positive Contact
3. Negative Contact
4. Power Button
5. 5-LED Indicator
OPERATION
5-LED INDICATOR ON BATTERY PACK
This lithium-ion battery pack is equipped with a 5-LED
indicator, press the power button to display the charge
level or its working condition, the LED indicator will be
illuminated for 10 seconds
Battery charge
5-LED
level/Working
indicator
condition
80% ≤ Charge
level ≤ 100%
60% ≤ Charge
level <80%
40% ≤ Charge
level < 60%
20% ≤ Charge
level < 40%
10% ≤ Charge
level < 20%
Charge level <
10%
Low voltage
Over
temperature
6
56 VOLT BATTERY — BA1400T/BA2240T/BA2800T/BA4200T/BA5600T
Self
maintenance
BATTERY PROTECTION
Remarks
The battery circuitry protects the battery pack from extreme
temperature, over-discharge, and over-charge. To protect
the battery from damage and prolong its life, the battery
5-LED shining green
pack circuitry will turn off the battery pack if it becomes
overloaded or if the temperature becomes too high during
use. This may happen in extremely high torque, binding,
and stalling situations. The battery pack will shut down with
4-LED shining green
power indicator shinning red for 10s when its operating
temperature exceeds 70°C, and will begin normal operation
when it returns to 67°C.
3-LED shining green
Notice: A significantly reduced run time after fully charging
the battery pack indicates that the batteries are near the end
of their usable life and must be replaced.
2-LED shining green
COLD WEATHER OPERATION
This Lithium-Ion battery pack will provide optimal
1-LED shining green
performance in temperatures between 10°C and 26°C.
When the battery pack is very cold, it may "pulse" for the
first minute of use to warm itself. Put the battery pack on
a tool and use the tool in a light application. After about a
1-LED flashing red.
minute, the battery pack will have warmed itself and will
operate normally.
5-LED flashing red.
The battery pack is nearly
WHEN TO CHARGE THE BATTERY PACK
depleted and needs to be
NOTICE:
charged immediately.
charged. Before using it the first time, fully charge the
5-LED shining red.
battery pack.
Cool the batter pack until
the temperature drops
below 67°C.
For BA1400T/BA2800T/
BA4200T/BA5600T 5
LEDs shine solid red for
10 seconds, then go out
and remain off for 10
seconds, then shine solid
red for 10 seconds again
or 5 LEDs flash green
-
every two seconds based
on different battery
version. Both indications,
the LEDs will run the
cycle until the self-
maintenance is finished.
For BA2240T no special
indicator.
Lithium-Ion battery packs are shipped partially