Dometic CAM80AHD Instructions De Montage Et De Service page 15

CAM80AHD
To fasten the cables you may require additional cable binders.
8.2 Mounting the camera
!
CAUTION!
Select a location for the camera and attach it so securely that it cannot under any
circumstances fall off and injure bystanders (e.g. by being knocked off by branches
brushing over the roof of the vehicle).
I
NOTE
If installing the camera alters the vehicle height or length specified in the vehicle
documents, your vehicle must be inspected by the appropriate authorities.
Make sure that you are in possession of documents verifying that your vehicle has
passed this inspection.
Observe the following installation instructions:
•
To provide a suitable viewing angle, the camera must be attached at a height of at least 2 m.
Ensure that you have a firm place from which to work when mounting the camera.
•
Ensure that the installation location of the camera is sufficiently firm (e.g. to prevent the camera
from being knocked down by branches that may brush over the roof of the vehicle).
Mount the camera bracket horizontally and in the middle of the rear of the vehicle (fig. 0,
•
page 6).
•
The most secure type of attachment is with screws fitted through the body. Please observe the
following instructions:
– There must be sufficient space for the mounting procedure behind the chosen installation
location.
– Suitable measures must be taken to prevent water penetrating through any holes made
(e.g. by using screws and sealant and/or spraying the outer attachment parts with a
sealant).
– The location on the body where you wish to attach the camera must be rigid enough to
allow the camera to be tightly fastened.
•
Check beforehand that there is sufficient room for the drill head to come out on the other side
(fig. 2, page 4).
•
If you are not sure about the location you have chosen, consult the vehicle manufacturer or
dealer.
I
NOTE
We recommend greasing the threads of the bolts to prevent corrosion.
When mounting the camera, proceed as follows:
➤ Hold the camera on the chosen location and mark at least two different points for the drill holes
(fig. a, page 6).
EN
Mounting the camera
15