GYS Multi PEARL 200-2 Mode D'emploi page 21

Translation of the original instructions
SWITCHING ON
The ON/OFF switch is located at the back of the machine. Turn the switch on the "I" position to start the generator. This switch
must not be turned off (to "O") while welding.
MIG MANUAL - FIG III
• Selecting MIG manual mode
• Wire speed adjustment
• Arc voltage adjustment
• Setting management torch in SPOT and
DELAY mode
MIG SYNERGIC - FIG III
• Selecting MIG Synergic mode
• Selecting the type of wire
• Selecting the wire diameter
MULTIPEARL 200.2 / 200.4 XL / 201.4
Keep button 2 pushed and at the same
time turn the upper knob until the display
shows MIG Manual. Release button 2 to
validate this selection
Turn the upper knob to adjust the wire
speed.
Turn the lower knob to adjust the arc
voltage.
• Keep button 3 pushed to select normal
mode.
• Keep pressing button 3 and at the same
time turn the upper knob to select SPOT
mode and to configure it. Adjustable
between 0.5 to 5 sec.
In the same way turn the lower knob to
configure the DELAY mode. Adjustable
between 0 to 5 sec."
Keep button 2 pressed and at the same
time turn the upper knob until "MIG
Synergic" is displayed.
Keep button 2 pushed and at the same
time press the lower knob to go to the
wire type selection menu. Select the wire
type with the upper knob.
Keep the button 2 pushed and at the
same time press the lower knob to go to
the wire diameter selection menu.
Select the diameter with the upper knob.
Then release the button 2 to validate.
MANUAL
+
+
+
+
+
EN
21