Repairs; Fault-Finding Messages; Elimination Of Scratches And Cigarette Burns - Teuco SEASIDE 641 HA Mode D'emploi

EN
If any part of the appliance fails to operate as it should, (e .g . failure of the lamp in the
underwater light), call the nearest Teuco Authorized Service Centre (see list attached) .
DIAGNOSTICS MESSAGES
The appliance is equipped with various safety features which monitor the operation of the
system . In the event of malfunction, the system responds automatically by deactivating the
function currently selected and displaying an error message .
TROUBLE OR FAULT
» CLE
» HO
- The temperature of the water in
the minipool is higher than 44 °C .
» HOH
- The temperature of the water in
the heater is higher than 51 °C .
» FLO
- The system is not sensing any
flow of water in the recirculation
circuit .
» rPF
» H2O
» HPF
REMOVING SCUFFS, SCRATCHES AND CIGARETTE BURNS
Firstly, make certain that the scratch or burn
has affected only the surface of the acrylic
material .
This type of repair must be entrusted to a pro-
fessional with the necessary skills .
The repair will always be noticeable on the
surface of the mini-pool .
16

REPAIRS

CAUSE
Filters dirty or blocked .
Temperature of water in the
minipool too high .
Sudden loss of electrical power with
water heater in operation . water
temperature too high
Pump valves closed or filter
blocked .
Problem with temperature probe .
Water level too low .
Safety temperature sensor problem .
ACTION
Clean the filters .
Set a lower temperature value and
wait for the water to cool .
If the fault persists, call the nearest
Teuco Authorized Service Centre.
Isolate the minipool from the power
supply and wait for the water to cool
down (about 2 hour) . Power the
system up again, and if the fault
persists, call the nearest Teuco
Authorized Service Centre.
Check that the pump valves are
open; clean the filters . Switch
power off and on again . If the fault
persists, call the nearest Teuco
Authorized Service Centre.
Call the nearest Teuco authorized
Service Centre .
Add water, and if the problem
persists, contact a
Authorized Service Centre.
Call authorized technical
assistance.
ACRyLIC
FIBREGLASS
641 HA
Teuco