Stand-By; Minipool Cover - Teuco SEASIDE 641 HA Mode D'emploi

EN

STAND-By

The stand-by function is utilised when filter cleaning
is carried out . The pump switches off .
Press the "Light" key for 8 seconds to set the
hydromassage unit in stand-by mode .
The writing "SBY/60" appears on the display and the
stand-by mode continues for 60 minutes .
If the water heating unit is functioning, the pump
switches off with a delay of 30 seconds in respect of
the actuation of the stand-by mode .
Press the "Light" key again for 5 seconds to exit
from the stand-by mode .

MINIPOOL COVER

Always keep the minipool protected (when it is not
used) by fitting the cover supplied, so as to reduce
the loss of heat and evaporation, avoid dirtying the
water and above all, for safety reasons if water is left
in the minipool .
For greater safety, the cover must be hooked using
the holding belts and closed using the key .
The cover was not designed to support loads.
Do not sit, walk or lie on the cover.
Do not place objects on it.
An unfixed or unclosed cover could be
dangerous.
Not following the cover fixing instructions could
be dangerous for the user.
Completely remove the cover before entering the
Minipool; a person could become entangled in it.
We recommend that at least two people carry
out thermal cover removal operations. The cover
must only be lifted and carried by its special
handles.
10
INSTRUCTIONS FOR USE
SBY/60
641 HA