Orlaco DDIN Mode D'emploi page 9

Note: During cranking off the vehicle and a weak battery the
power supply to the display could go below 11,5V/DC. If this
happens the display could startup without sufficient power
supply to the camera(s) resulting in a non-functioning camera
with no image on screen. Assuming that the battery power
recovered after the cranking to >11,5V/DC please restart the
display by pressing the on/off button to activate the display
and camera(s).
Disassembling of the DDIN monitor. Remark:
Does not apply to article 0208300 and all
RLCD's.
Step 1
- Remove the suncover by sliding it upwards in the arrow
direc tion and then forwards;
Step 2
- Insert the U shaped demounting tool into the holes as shown;
Step 3
- Tweak the dismounting tool in both holes & pull the screen
slightly out of the dashboard;
- Pay attention to step 4 before completely removing the
screen from the dashboard;
Step 4
- Do the same thing on the other side;
UM0208201 R3-5
ob jec ts
in
mo nit or
are
clo se r
tha n
the y ap
pe ar
1
1
ob jec ts
in
mo nit or
clo se r are
tha n
the y ap
pe ar
2
2
ob jec ts
in
mo nit or
are
clo se r
tha n
the y ap
pe ar
3
3
ob jec ts
in
mo nit or
clo se r are
tha n
the y ap
pe ar
4
4
9