Master BP 13 INOX Notice D'utilisation page 19

A. Construction and characteristics
Transportable terrace/garden heater with tank housing
•
Casing in steel with powder-coating or stainless steel
•
Gas hose connections with metal clamp (screw caps for Germany)
•
Heat emission from reflector
•
B. Specifications
Use propane or butane gas only
•
Max. wattage: 13000 watts
•
Min. wattage: 5000 watts
•
Consumption:
•
GAS CATEGORY:
TYPES OF GAS:
GAS PRESSURE:
CONSUMPTION:
With CE certificates
•
C. Table of injector
GAS CATEGORY:
TYPES OF GAS:
GAS PRESSURE:
TOTAL HEAT
INPUT (Hs): (Qn)
INJECTOR SIZE:
The hose and regulator assembly must conform to local standard codes.
•
Regulator outlet pressure should meet the corresponding gas category in the table of injector.
•
The appliance requires approved hose in 1.4m length.
•
PROBLEMS CHECK LIST
PROBLEM
Pilot will not light
Pilot will not stay on
Burner will not light
I
3+(28-30/37)
Butane Propane
28-30 mbar 37 mbar
450-870 g/h 640-1230 g/h
I
3+(28-30/37)
Butane Propane
28-30 mbar 37 mbar
13 kW (870 g/h)
1.90 mm for main burner
0.18 mm for pilot burner
PROBABLE CAUSE
Gas valve may be OFF
Tank fuel empty
Opening blocked
Air in supply system
Loose connections
Debris around pilot
Loose connections
Thermocouple Bad
Gas leak in line
Lack of fuel pressure
Pressure is low
Opening blocked
Control not ON
Thermocouple Bad
Pilot light assembly bent
Not in correct location
I I
3B/P(30) 3B/P(50)
LPG Gas Mixtures LPG Gas Mixtures
30 mbar 50 mbar
550-1060 g/h
I I
3B/P(30) 3B/P(50)
LPG Gas Mixtures LPG Gas Mixtures
30 mbar 50 mbar
1.70 mm for main burner
0.18 mm for pilot burner
Turn the gas valve ON
Refill LPG tank
Clean or replace opening
Purge air from lines
Check all fittings
Clean dirty area
Tighten connections
Replace thermocouple
Check connections
Tank near empty. Refill LPG tank.
Tank near empty. Refill LPG tank.
Remove and clean
Turn valve to ON
Replace thermocouple
Place pilot properly
Position properly and retry
I
3B/P(37)
LPG Gas Mixtures
37 mbar
I
3B/P(37)
LPG Gas Mixtures
37 mbar
1.80 mm for main burner
0.18 mm for pilot burner
SOLUTION