Brother KIT I Guide D'installation page 8

If an error occurs, a message will appear in
red.
Check that symbols or characters other than
numbers have not been entered. Then type in
the correct internal machine identification
number(No.) and then click "Next".
h
Using a coin, etc., scrape the silver foil off the
"Activation Card", and then type in the code
and then click "Next".
If an error occurs, a message will appear in
red.
Check below list for possible entry error(s).
✓ Are symbols or characters other than letters and
numbers entered?
✓ Has the uppercase letter "I" been entered in place of
the number "1"?
✓ Has the uppercase letter "O" been entered in place
of the number "0"?
Then type in the correct activation code and
then click "Next".
Memo
• The uppercase letter "I" and "O" are not used in the
activation code. Also, no symbols are used in the
activation code.
• The activation code is valid for only one time
activation. The same activation code cannot be
used again. Multiple machines cannot be connected
using the same activation code.
6
i
Carefully verify that the information has been
entered correctly and then click "Certify".
Memo
• To change the entered information, click "Back".
If an error occurs, a message will appear in
red.
Check below list for possible error(s).
✓ Verify that the activation code and internal machine
identification number (No.) have been entered
correctly, and then repeat the procedure from step
b
.
✓ The activation code is valid for use with only one
designated internal machine identification number
(No.). Check that the activation code has been
entered correctly, and then repeat the procedure
b
from step .
✓ Check the Internet connection, and then click
"Certify" again.
j
Write down the 8-digit Certification Key that
appears.
Note
• After upgrading the sewing machine to KIT
Certification Key must be entered in the sewing
machine Settings screen.
I
, the