Backrest - Zippie Simba Notice D'utilisation

Backrest

Angle-adjustable back
The backrest angle is adjusted by altering the position of the backrest
mounting. The screws (1) must be loosened and removed on both sides. The
backrest mounting should now be adjusted until the desired angle is reached.
Then the screws (1) must be re-tightened and secured (Fig. 5.18)
CAUTION!
The screws must be re-tightened. Otherwise the angle adjustment will be
lost.
Folding backrest
Release the backrest by pulling the cord and at the same time, pushing it
forward to fold it down. To return the backrest to its original position, this must
be pulled back as far as possible until it locks into place on both sides.
DANGER!
If the backrest is pulled too far backwards, operating the brakes could
cause the user to fall backwards. Therefore, please make sure that both
backrests lock into place.
WARNING!
When folding the backrest down, please make sure that your fingers do
not get caught.
Backrest in the relax position
A relax position can be achieved with a 10° backrest angle. Pull the cord
located on the backrest to release it, and pull it backwards until both backrest
tubes lock into place.
WARNING!
If the backrest is pulled too far backwards, operating the brakes could
cause the user to fall backwards. Therefore, please make sure that both
backrests lock into place.
WARNING!
When folding the backrest down, please make sure that your fingers do
not get caught.
Adjustable Back Sling
The adjustable back sling can be adjusted for tension by using several
straps. The back sling upholstery can be accessed from the inside via an
opening and can be padded to suit individual tastes.
Height-adjustable backrest
The back height may be set to various back heights, in 2.5 cm steps.
The adjustment ranges are 20-25 cm, 25-30 cm, 30-35 cm and 35-40 cm.
Release the screws (1) and set the backrest to the desired height. Tighten up
the screws again (see the page on torque) (Fig. 5.19).
Simba
Fig. 5.18
Fig. 5.19
1
21
1 1
Rev.H