Hilti DX450 Mode D'emploi page 20

Disposal
Most of the materials from which Hilti power actuated tools are manufactured can be
recycled. The materials must be correctly separated before they can be recycled. In many
countries, Hilti has already made arrangements for taking back your old powder actuated
tools for recycling. Please ask your Hilti customer service department or Hilti sales
representative for further information.
Manufacturer's warranty – DX tools
Hilti warrants that the tool supplied is free of defects in material and workmanship. This
warranty is valid so long as the tool is operated and handled correctly, cleaned and serviced
properly and in accordance with the Hilti Operating Instructions, and the technical system is
maintained. This means that only original Hilti consumables, components and spare parts, or
other products of equivalent quality, may be used in the tool.
This warranty provides the free-of-charge repair or replacement of defective parts only over the
entire lifespan of the tool. Parts requiring repair or replacement as a result of normal wear and
tear are not covered by this warranty.
Additional claims are excluded, unless stringent national rules prohibit such exclusion.
In particular, Hilti is not obligated for direct, indirect, incidental or consequential dam-
ages, losses or expenses in connection with, or by reason of, the use of, or inability to
use the tool for any purpose. Implied warranties of merchantability or fitness for a par-
ticular purpose are specifically excluded.
For repair or replacement, send tool or related parts immediately upon discovery of the defect
to the address of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to warranty and supersedes all prior or con-
temporaneous comments and oral or written agreements concerning warranties.
20
Printed: 24.03.2014 | Doc-Nr: PUB / 5069832 / 000 / 03
Health and safety of the user
Noise information
The following table provides noise measurement information:
Powder-actuated tool
Type:
Model:
Caliber:
Power setting:
Application:
Declared measured values of noise characteristics according to 2006/42/EC
Machinery Directive in conjunction with E DIN EN 15895
Noise (power) level:
Emission noise-pressure level in the work station:
Peak sound pressure emission level:
Operation and set-up conditions:
Set-up and operation of the pin driver in accordance with E DIN EN 15895-1 in the semi-
anechoic test room of Mü l ler-BBM GmbH. The ambient conditions in the test room
conform to DIN EN ISO 3745.
Testing procedure:
Enveloping surface method in anechoic room on reflective surface area in accordance
with E DIN EN 15895, DIN EN ISO 3745 and DIN EN ISO 11201.
NOTE: The noise emissions measured and the associated measurement uncertainty
represent the upper limit for the noise values to be expected during the measurements.
Variations in operating conditions may cause deviations from these emission values.
1 ± 2 dB (A)
2 ± 2 dB (A)
3 ± 2 dB (C)
Vibration
The declared total vibration value according to 2006/42/EC does not exceed 2.5 m/s
Further information regarding the health and safety of the user can be found at the Hilti web
site: www.hilti.com/hse
DX 450
Serial production
6.8/11 yellow
3
Driving X-CR14 P8 fastener
on 10 mm steel (390 MPa)
L 1 111 dB(A)
WA, 1s
L 2 105 dB(A)
pA, 1s
L 3 137 dB(C)
pC, peak
2 .