Hilti DX450 Mode D'emploi page 15

Assembly
1
Insert piston in its guide.
5
Screw on baseplate as far as it goes, then
screw back until it snaps in place. Swing over
cocking lever to resting position. Connector
and link will automatically latch again.
Printed: 24.03.2014 | Doc-Nr: PUB / 5069832 / 000 / 03
2
Insert piston guide in housing. (Slot in piston
guide must align with silencer).
3
Press stop ring on fastener guide.
Insert fastener guide in piston guide.
4
Slide over baseplate.
(Recess in baseplate must align with raised
part of fastener guide.)
15