SEVERIN HC 6857 Mode D'emploi page 8

Dear Customer,
Before using the appliance, the user should
read the following instructions carefully.
Connection to the mains supply
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label of the appliance.
This product complies with the directives
which are binding for the CE-labelling.
Familiarisation
1. Round brush
2. Air outlet openings
3. Lock/release button
4. Cool-air button
5. 3-position switch
6. Housing
7. Air inlet openings
8. Power cord with swivel
9. Curling-attachment
10. Round brush with retractable bristles
11. Warm-air brush
12. Semi-round-brush
13. Styling nozzle
14. Hanging loop
Important safety instructions
●
Caution! Do not use the
appliance in the vicinity of a
bath, shower or swimming-
pool, over a washbasin filled
with water or any other receptacle
containing water.
●
There is always a risk when the appliance
is operated near water even when it is
switched off. Therefore, if the appliance
is being used in a bathroom always
remove the plug from the wall socket
after use.
Additional protection is offered by fitting
an earth-leakage circuit-breaker with a
rated tripping current not exceeding
30mA into your bathroom installation.
Hair-styling-Set
Please consult a qualified electrician.
●
Protect the appliance from moisture and
splashing water and do not operate it
with wet hands.
●
Electric heating appliances operate at
very high temperatures. Do not touch
any part of the appliance except the
housing. Burns can occur from touching
the hot parts.
●
Do not use the appliance on synthetic
hair-pieces or wigs. The heat emitted
might cause damage to the synthetic
fibres.
●
Make sure the air intake and outlet
openings are not blocked by fingers or
hair and that no lint particles are allowed
to accumulate in the air intake.
●
Should the unit automatically switch off
during use, the integral overheating
protective device may have been
activated. The appliance will switch on
again after a sufficient cooling down
period.
●
Before the appliance is used, the main
body as well as any attachment fitted
should be checked thoroughly for any
defects. Should the appliance, for
instance, have been dropped onto a hard
surface, it must not be used any longer:
even invisible damage may have adverse
effects on the operational safety of the
appliance.
●
Do not leave the appliance unattended
while in use.
●
To prevent damage to the power cord,
- do not bend or kink the cable,
especially where it leaves the housing,
- do not pull on the cord,
- do not coil the power cord around the
appliance.
●
Do not place the appliance on any
surface sensitive to heat during or
immediately after use.
●
Do not operate the appliance if it is
stored on the hanging loop.
●
Make sure hot attachments are kept
away from the scalp.
●
When removing the plug from the wall
8