Candy TRIO 503/1 Notice D'emploi Et D'installation page 51

FAULT
7 - Load of dishes is only
partially washed
8 - Presence of white spots on
dishes
9 - Noise during wash
10 - The dishes are not
completely dry
CAUSE
See causes for No 5
Bottom of saucepans have not been
washed well
Edge of saucepans have not been
washed well
Spray arm is blocked
The dishes have not been properly
loaded
The end of the outlet hose is in the
water
The incorrect amount of detergent
has been measured out; the
detergent is old and hard
The tap of the salt dispenser is not
closed very well
The wash programme is not thorough
enough
Water is too hard
The dishes knock against one
another
The revolving arm knock against the
dishes
Inadequate air flow
REMEDY
Check
Burnt on food remains must be
soaked before putting pans in
dishwasher
Reposition saucepans
Remove spray arm by unscrewing
ring nut clockwise and wash under
running water
Do not place the dishes too closely
together
The end of the outlet hose must not
come into contact with the outflow
water
Increase the measure according to
how dirty the dishes are and change
detergent
Tighten it fully.
Choose a more vigorous programme
Check salt and rinse aid level and
regulate amount. Should the fault
persist, Contact Service Centre.
Load dishes better onto the basket
Load dishes better
Leave the dishwasher door ajar at
the end of wash program to allow
dishes to dry naturally
51