Publicité
Les langues disponibles
Les langues disponibles
Please unfold page 3. Then you can always see the
operating elements and connections described.
1 Connections and Operating Elements
1.1 Camera
1 Mounting plate
2 Hexagon screw for fixing the mounting plate
3 BNC plug for connection to the jack TO CAMERA
(21) of the power supply unit
4 Ring for covering the setscrews (6) of the dome
5 Hexagon screw for fixing the ring (4)
6 Hexagon screws for fixing the dome (7)
7 Dome
8 Bracket for the camera module
9 Setscrews; for tilting the camera around the hori-
zontal axis release the screws and then retighten
them
10 Setscrews; for panning the camera around the axis
of the lens release the screws and then retighten
them
11 Zoom adjusting lever; use the supplied socket
wrench for releasing and fixing
12 Focus adjusting ring of the lens
13 Setscrew for the focus adjustment at the lens
14 Foam rubber ring as a protection against disturbing
reflections of the LED light in the dome
1.2 Power supply unit
15 Power LED
16 POWER switch
17 Mains cable for connection to 230 V~/50 Hz
18 Fuse holder;
Only replace a blown fuse by one of the same type
19 Four sliding switches for matching the video level
or for compensating level loss when using a long
connection cable to the camera; adjustment see
table on page 9
20 Video output for connection to a monitor
21 Connection jack for the camera
(video input and operating voltage output of the
camera)
2 Safety Notes
The units (power supply unit and camera) correspond
to all required directives of the EU and are therefore
marked with
.
WARNING The power supply unit is supplied with
hazardous mains voltage (230 V~).
Leave servicing to skilled personnel
only. Inexpert handling or modification of
the unit may cause an electric shock
hazard.
It is essential to observe the following items:
The power supply unit is suitable for indoor use only.
G
Protect the units against extreme temperatures
G
(admissible ambient temperature range -10 °C to
+50 °C) and the power supply unit in addition
against dripping water and splash water, and high
air humidity.
Do not place any vessels filled with liquid, e. g. drink-
G
ing glasses, on the power supply unit.
The camera housing is watertight according to IP 68,
G
with a maximum water depth of 1 m and a maximum
time of immersion of 2 days.
The heat being generated in the power supply unit
G
must be carried off by air circulation. Therefore, the
air vents at the housing must not be covered.
Do not insert anything into the air vents! This could
G
result in an electric shock.
Do not set the power supply unit into operation, and
G
immediately disconnect the mains plug from the
mains socket if
1. there is visible damage to the units or to the mains
cable,
2. a defect might have occurred after a drop or simi-
lar accident,
3. malfunctions occur.
The units must in any case be repaired by skilled
personnel.
A damaged mains cable must only be replaced by
G
skilled personnel.
Never pull the mains cable to disconnect the mains
G
plug from the mains socket, always seize the plug!
For cleaning do not use any aggressive detergents
G
or chemicals. For the power supply unit only use a
dry, soft cloth.
No guarantee claims for the units and no liability for
G
any resulting personal damage or material damage
will be accepted if the power supply unit or the
camera is used for other purposes than originally
intended, if they are not correctly connected, oper-
ated, or not repaired in an expert way.
Important for U. K. Customers!
G
The wires in this mains lead are coloured in ac-
cordance with the following code:
green/yellow = earth
blue = neutral
brown = live
GB
7
Publicité
