Bpt TARGHA GSM VR Série Mode D'emploi page 9

English
General Notes
• Read the instructions carefully before beginning the installation and carry out
the actions as specified by the maker;
• The installation, programming, putting into operation and maintenance of the
product must be carried out only by qualified technical personnel, correctly
trained with regard to respecting the regulations in force, including the imple-
mentation of accident prevention measures;
• Before carrying out any cleaning or maintenance operation, disconnect the
device from the power supply;
• The equipment must be destined solely for the use for which it was expressly
designed.
• Failure to comply with the above instructions may compromise the unit's safety.
• The manufacturer declines all liability for any damage as a result of improper,
incorrect or unreasonable use.
Safety information
This device is a low power radio receiver-transmitter. When it is in operation, it
sends and receives energy by radio frequency (RF). The device produces mag-
netic fields, therefore it must be kept away from magnetic items such as disks,
tapes, etc.
Operating the device near to electrical and electronic devices such as radios,
telephones, televisions and computers can cause interference.
Interference
This device, like all wireless devices, is susceptible to interference which might
affect the performance of the device.
Use in Hospitals
It is not recommended that the device be used in hospitals and health centres,
given that devices sensitive to external radio frequency signals may be in use.
Use in proximity to explosive materials
Do not use the device in fuel storage depots, chemical factories or in areas where
explosive gases are present or where works using explosives are in progress. It
will be necessary to respect restrictions and comply with any standards or reg-
ulations in force.
Mode of use
Do not use the device in contact with the human body, do not touch the aerial unless
absolutely necessary. Use only approved accessories. Consult the manuals of any
other devices to be connected to this device. Do not connect incompatible devices.
DISPOSAL
Do not litter the environment with packaging material: make sure it is disposed
of according to the regulations in force in the country where the product is used.
When the equipment reaches the end of its life cycle, avoid discarding it in
the environment.
The equipment must be disposed of in compliance with the regulations in
force, recycling its component parts wherever possible.
Components that qualify as recyclable waste feature the relevant symbol and
material's abbreviation.
y
Note
Before installing the device it is essential to check that there is an adequate GSM
signal in the place you intend to install it: to do this you just need to put the SIM-
CARD you purchased into a mobile phone and check its reception.
If the reception is not good, it will be necessary to install the device somewhere
else where there is a better signal, or alternatively to use an external aerial.
We would advise that BPT S.p.A. assumes no responsibility with regard to the
failed sending, failed receipt, delayed sending or delayed receipt of the SMS
message by the entry panel, when this can be attributed to reception of the
relative signal or to problems of any nature relating to the business of the tele-
phone provider;
Some Providers' SIM-CARDs have expiry dates: it is recommended that you bear
this in mind when programming the entry panel.
Description
TARGHA GSM VR is a GSM audio entry system that can make audio calls in
speaker mode to telephone numbers on fixed and mobile networks, by pressing
buttons.
Using 2 on-board relays, you can command the opening of a door or gate re-
motely, by pressing (during call) the
on your phone's keypad.
Finally, with SMS messages, you can programme, manage and ask for informa-
tion about the selected parameter.
MAX 4 call buttons (1, 2 or 4)
Memory of up to 20 telephone numbers (5 for each user)
Up to 9 call repetitions (loop sequence)
Invariable call sequence
Up to 9 minutes of conversation (automatic hang-up)
Buttons can be disabled
External audio can be disabled up to answering
Variable system password
Buttons test
Relay test
Adjustable external audio
Sending and receiving SMS
Quad Band 900/1800 MHz GSM/GPRS modem
Push-pull type microSIM card slot
Light Indicators: Power supply and status (inside module)
Technical data
Type
Max power supply (VDC)
Consumption in stand-by mode 18 V [mA]
Consumption during call 18 V [mA]
Breaking capacity [mA] max 50 V
Aerial cable length [m]
Temperature range [°C]
Protection rating [IP]
A
Dimensions
Installation
The installation stages for the TARGHAVR GSM include:
• Attachment to wall of the wall-mounted
B C
• Insertion of SIM card a
• Connection of power supply and any relays;
• Programming and settings via SMS;
After taking the product out of the box, check it is all intact. Before connect-
ing the power supply, the SIM card must be inserted into the device and once
switched on the network coverage must be checked via the network status LED.
Inserting SIM card
Before beginning the installation of the product, insert the SIM card into the slot
B C
inside the entry panel a
TARGHAVR GSM supports any PLUG-IN type SIM (3V/1.8V). In order to avoid
damaging the SIM or losing information we recommend you do not touch the
gold part of the SIM (where the contacts are).
key for relay 1 and the key for relay 2
TARGHA GSM VR1-2-4
12- 26
30
300
500
3
-15 / +50
54
B C
or recessed base
a ;
a .
;
9