ARIETE eco power 2732 Mode D'emploi page 12

EN
PRE-MOTOR FILTER CLEANING/REPLACEMENT
The pre-motor fi lter needs to be cleaned regularly and replaced every 6- 9 months, according to use.
• Remove the bag support (FIG. 8).
• Remove the fi lter (FIG.9) and shake it vigorously to clean it. If it is very dirty, wash it with lukewarm
soapy water; rinse it well and leave to dry naturally.
Important
DO NOT dry the fi lter using artifi cial means. To replace the fi lter, contact your Assistance Centre.
• Refi t the fi lter in its housing, making sure that the rough surface of the fi lter is visible.
• Then refi t the dust bag and make sure that the fi lter compartment is in place before use.
EXHAUST FILTER CLEANING/REPLACEMENT
The outlet fi lter needs to be cleaned regularly and replaced every 6- 9 months, according to use.
• Remove the cover of the exhaust fi lter, using the lever (FIG. 10).
• Lift out the fi lter and shake it vigorously to clean it. If the fi lter is very dirty, wash it with lukewarm soapy
water; rinse it well and leave to dry naturally.
Important
DO NOT dry the fi lter using artifi cial means. To replace the fi lter, contact your Assistance Centre
• Refi t the fi lter in its housing, making sure that the rough surface of the fi lter is visible and that the fi lter
holder is in place correctly before using.
TROUBLESHOOTING
THERMAL CUT OUT
The vacuum cleaner is equipped with a thermal cut-out device to protect it if the motor should overheat.
If the vacuum cleaner should suddenly stop on its own, proceed as follows:
• Switch off and unplug the vacuum cleaner.
• Look for the cause of the overheating (suction tube clogged, dirty fi lter, etc.).
• Clean the tube, empty the dust container and clean the fi lters if necessary.
• Wait about 30-40 minutes to give the motor time to cool down.
• After 30-40 minutes, plug the appliance into the mains power and switch it on. The vacuum cleaner
should work now.
• If it continues not to work, wait a further 20 minutes and then try again.
• If the appliance still does not work, contact your nearest Assistance Centre.
10