Télécharger Imprimer la page

ARIETE eco power 2732 Mode D'emploi page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
USING THE APPLIANCE
Important note!
Before using the vacuum cleaner, remove any large or sharp objects from the fl oor to avoid cau-
sing damage to the appliance. Before use, wind out the cord for its whole length and plug in the
appliance. To switch on the appliance, press the On/Off switch on the cleaner (FIG. 4).
Important
In some cases, it is possible for a whistling sound to be heard when the appliance is switched on:
this is not a fault and it will disappear with use.
SUCTION FLOW CONTROL
The secondary air opening (O) is on the handgrip and it is used to adjust suction strength (FIG. 5). The
larger the opening, the less the suction power and vice versa. To open the suction opening, push the
lever downwards and upwards to close it. The opening should be adjusted according to surface type:
Minimum power for curtains and delicate materials.
Medium power for cushions, mattresses and carpets.
Maximum power for tiled or wooden fl ooring or other hardy materials with a good deal of dirt.
MOTOR POWER CONTROL
It is possible to adjust the suction power using the slider (FIG. 11). We recommend using minimum po-
wer for delicate materials. Select the medium setting for mattresses, upholstered furniture and carpets
or rugs.
Select the maximum power setting for tiled or wooden fl ooring or other hardy materials with a good deal
of dirt.
Important note!
Switch off the vacuum cleaner immediately if the air openings, brushes or telescopic tube become
clogged or blocked. Remove the blockage before switching on the vacuum cleaner again.
AFTER USING THE VACUUM CLEANERT
After use, switch off the appliance by holding down the On/Off button (E); unplug the appliance and
rewind the power cord by holding down the cord rewind button (C) on the appliance. The cord will be
rewound inside the container.
It is possible to use the rear (S) and bottom (V) hooks to insert the telescopic tube and store the applian-
ce together with its attachment so as to take up as little room as possible (FIG. 6).
Important note!
While rewinding the cord, guide it with one hand to as not to hurt yourself and take great care if
there are children or pets in the vicinity.
CLEANING AND MAINTENANCE
Important note!
Before carrying out any cleaning or maintenance operation, switch off and unplug the appliance
from the mains
DUST BAG REPLACEMENT
When the bag full indicator (B) turns red, the bag needs changing.
• Lift out the bag compartment, pushing the bag housing upwards (FIG. 7).
• Take out the bag support (FIG. 8), taking care not to force it and once the support is out, slide the stiff
cardboard part of the bag into out of the guides and throw away the bag.
• Fit a new bag, sliding the stiff card into the guides, then place the support inside the housing.
• Close the lid of the compartment.
9
EN

Publicité

loading