Alarm Info: warns light flashing when camera device inform alarm. Support kinds of alarms record and setup or remove the alarm
setting, clear the alarm information.
Zoom-in: use the mouse to do local zoom for the video display area by scrolling the mouse wheel.
PTZ control: up/ down/ left/ right/ auto/ adjust the PTZ rotate speed, etc. As figure 3-8.
Lens control: do scaling, focus, iris operation, as figure 3-8.
Brightness: adjust the image brightness. As figure 3-9.
Contrast: adjust the image contrast. As figure 3-9.
PTZ setting: preset setting, cruise, track setting, linear scan, idle, IR light, as figure 3-10.
Preset setting: adjust the camera to the appointed angle and location through directional buttons and then select a
preset number on the preset drop down list, click
Call preset: select the preset number which needed to call on the preset drop down list, then click
Cruise: 255 presets addable, stay time 1-255s adjustable, cruise speed 1-7 levels selectable. All cruise tracking can be
call and delete independently.
Clear cruise: Click
Call cruise: Click
Tracking path setting: Select a number at the tracking drop down list, click
Call tracking path: select a number at the tracking drop down list, click
Linear: select a number at the linear drop down list, click
operation, then click
and the vertical angle depend on the final position, linear path is two point minimum path
Call linear: select a number at the linear drop down list, click
Idle : Idle include preset setting, cruise scan, tracking, scan. Click
to save the idle ope setting, click
When set idle successfully, speed dome camera will do idle operation after the setted idle time
IR light: Auto/ Manual selectable, when select Auto, it will turn on the IR led according to the zoom module multiples, near
open for 1X, middle-open for 2-4X, far open for 5X or 5X later. When select Manual, there All close/ near open/ middle open/
near middle open/ far open/ far near open/ middle far open/ all open totally 8 kind of choices
Masking: no function
•
Cyclotron arrow: restore the default parameters. As figure 3-10.
to set it.
to clear all cruise scan setting
to call setted cruise scan
to save and exit the tracking path setting.
to save and exit the linear scan setting. Linear scan only supported horizonal scan,
Figure 3- 8
, and do a serious PTZ operation, then click
to call tracking path
to set the linear scan initial position and do a serious PTZ
to call linear scan
to set idle and the idle time is 1-15 min selectable, click
to verify whether the idle setting completed.
to call it.
9